Herunterladen Diese Seite drucken

Operation; Preparing The Device For Use; Changing The Nozzle; Further Examples Of Uses In The House, Car And Garden - Parkside PHLG 2000 C2 Bedienungsanleitung

Vorschau ausblenden

Werbung

Inhaltsverzeichnis

operation

Operation
Q

Preparing the device for use

Q
CAUTION! When using the device, never
allow the ventilation slots to be covered.
CAUTION! DANGER OF BURNS! Do not
touch the hot nozzle.
Switching on the device:
P ress the oN / oFF switch
or "II".
Switching off the device:
P ress the oN / oFF switch
Adjusting the air quantity and temperature:
You can use the temperature and air quantity control
to set two different blower levels. It is therefore
2
possible to select the appropriate quantity of air and
temperature in accordance with the intended use:
Setting I
300 l / min
Setting II
500 l / min
Use as free-standing unit / during
cooling (see Ill. D):
A lways set the device down upright on
a level surface, this will allow
· you to have both hands free.
· the device to cool.

Changing the nozzle

Q
Too much heat causes paints
and plastics to ignite.
CAUTION! Do not inhale the resulting vapours.
Protector nozzle
4
and varnish (see Ill. B):
P lace the protector nozzle
tube
.
3
T he spatula shape of the nozzle ensures the air
is properly directed. Use a separate spatula for
removing paint or varnish.
14 GB
into setting "I"
2
into setting "0".
2
350 °C
550 °C
– for removing paint
on the outlet
4
Flat nozzle
– for detaching glues,
5
softening paint (see Ill. C):
P lace the flat nozzle
D o not apply heat for too long a period, as
burnt paint becomes much more difficult to
remove. Many glues can be softened by warm-
ing. Glued connections can then be detached
and excess glue removed.
Reducing nozzle
6
P lace the reducer nozzle
outlet tube
.
3
U se the reducing nozzle
sleeves and film.
Further examples of uses in
Q
the house, car and garden
Defrosting water pipes:
Notice! It must not be used for thawing PVC pipes.
Notice! It is often very difficult to tell the difference
between gas pipes and water pipes. If in doubt, ask
a competent person.
Notice! Copper pipes are joined using tin solder
and must not be heated above 200 °C.
Loosening a threaded connection:
H eating the threaded connection carefully can
often allow the connection to be released.
Removing weeds:
T he heat dries out the weeds and microorganisms.
Lighting barbecue charcoal (see Ill. E):
Do not use methylated alcohol.
P ush the barbecue lighting nozzle
hot air nozzle
.
3
C harcoal ignites in a few minutes.
Wax removal:
Y ou can remove wax residues from skis / snow-
board or from candle holders. Use the amount
of care appropriate to the product.
on the outlet tube
5
– for welding plastic:
on the
6
for heat-shrinkable
6
on to the
7
.
3

Werbung

Kapitel

Inhaltsverzeichnis
loading