GB
IE
Before each use, check the equipment
for obvious defects such as loose, worn
or damaged components and check that
screws or other parts are sitting correctly.
In particular, check the grinding disk (
19). Replace damaged parts.
Cleaning
Do not use cleaning agents or sol-
vents. Chemical substances may
attack plastic parts of the equipment.
Never clean the equipment under
running water.
•
Clean the equipment thoroughly after
each use.
•
Clean the ventilation openings and the
surface of the equipment with a brush
or cloth.
Replacement parts/accessories
Spare parts and accessories can be obtained at www.grizzly-service.eu
If you do not have internet access, please contact the Service Centre via telephone
(see "Service-Center" page 17). Please have the order number mentioned below ready.
Position
Position
Instruction
Exploded
manual
drawing
1,2
Set 3
10
35
14
Set 2
19
62
19a,19b Set 1
14
Storage
•
•
Waste disposal and en-
vironmental protection
Be environmentally friendly. Return the
tool, accessories and packaging to a recy-
cling centre when you have finished with
them.
Hand over the device at an utilization loca-
tion. The plastic and metal parts employed
can be separated out into pure materials
and recycling can be implemented. Ask
your Service Center about this. Defective
units returned to us will be disposed of for
free.
Description
Spark protection with adjusting screw
Grinding belt
Grinding belt, pack of 5
On/off-switch
Grinding disk
Grinding disk nut and clamping flange
Store the appliance in a dry place well
out of reach of children.
Grinding disks must be stored dry and
upright and are not to be stacked.
Machines are not to be place with
domestic waste.
Order
number
91103042
91103044
91103046
91103041
91103043
91103040