Grinding With The Grinding Disc; Tape Loops; Change Grinding Belt; Change Grinding Disc - Parkside PSBS 240 B2 Originalbetriebsanleitung

GB IE
After switching on the device, wait until the
device has reached its max. speed. Only
then must you start with the grinding.
The disk will continue to
run after the equipment is
switched off. There is a risk
of injury.
Test run:
Before starting work and after each
change of grinding disk, carry out a test
run of at least 60 seconds with no load.
Switch off the equipment immediately if the
disk runs lumpy, substantial vibrations oc-
cur, or abnormal noises are generated.
Grinding with the grinding
disc
The arrow on the protective hood
( 3) shows the direction of rota-
tion of the grinding disc.
• Place the workpiece on the workpiece
support ( 18) and slowly bring it to
its desired angle on the grinding disc
( 19).
• Move the workpiece slightly from side
to side in order to achieve an optimal
grinding result. This way, the grinding
disc is worn uniformly. Occasionally,
allow the workpiece to cool down.

Tape loops

The arrow on the protective hood
( 9) shows the direction of rota-
tion of the grinding belt.
• Firmly hold the workpiece, do not exert
any strong force.
• Move the workpiece slightly from side
to side in order to avoid a one-sided
12
wear of the grinding belt.
• Always grind the pieces of wood in the
direction of the wood grain in order to
avoid chipping.

Change grinding belt

1. Loosen the 3 fixing screws (11)
and hang out the grinding belt
cover (12).
2. Loosen the clamping screw (8) by
a few rotations.
3. Press the clamping lever (7) down-
wards and detract the grinding
belt (10).
4. Place the new grinding belt (10)
in the centre on the upper (20a)
and lower (20b) rollers and let go
of the clamping lever (7).
5. Tighten the clamping screw (8) and
mount the grinding belt cover (12).
Set the tape run:
6. Loosen the nut (21a) of the ad-
justable screw (21) with a ring
spanner. The tape run accuracy is
set by the turning the adjustable
screw (21) with a screwdriver.
7. Check the tape run by manually
turning the grinding belt.
8. Re-tighten the nut (21a).

Change grinding disc

Information on replacement:
• Never operate the device without
protective equipment.
• Ensure that the rotation speed
stated on the grinding disc (
19) is the same or higher than the
nominal rotation speed of the de-
vice.
• Ensure that the grinding disc
dimensions match those of the de-
vice.