Troubleshooting - Pioneer CT-W505R Bedienungsanleitung

TROUBLESHOOTING

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check
the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being
used. If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized service center or
your dealer to carry out repair work.
Symptom
POWER
Cannot turn power on.
CASSETTE DOOR
The door does not open.
The door does not close.
PLAYBACK
Immediately stops.
The level meter does not
work.
No sound
RECORDING
The recording indicator
does not light up.
The level meter does not
work.
Immediately stops.
Cannot record
No sound.
REC LEVEL control does
not function.
Cause
• The power plug is disconnected.
• The component (stereo amplifier, audio timer, etc.)
to which the power cord is connected is off.
• The deck is not in stop mode (tape is moving).
• Power was turned off with the tape moving.
• The cassette is not properly loaded.
• The tape is completely wound.
• The tape is slack.
• The tape is blank.
• The tape head is dirty.
e The amplifier input selector is not correctly set.
e The amplifier volume level setting is too low.
e Connection problems (wrong connection, cord
removed, poor contact, broken wire.)
e The cassette erasure prevention tabs are broken.
a REC LEVEL control is set too low.
a The amplifier is not delivering a recording signal
(from the tuner, CD player, etc.),
a Wrong connection, connection cord removed, poor
contact, broken wire.
a The tape is completely wound,
a The tape is slack.
a The head is dirty.
a Connection problems (wrong connection, cord
removed, poor contact, broken wire.)
a The ALCA is being operated,
a The tape is being copied (with TONS).
Remedy
e Connect the power plug,
a Turn the stereo amplifier or audio timer on.
a Press the stop (■) button,
a Turn power on.
a Reinsert the cassette.
a Play back in the opposite direction,
a Rewind the tape,
e Take up the slack (see page 4).
e Replace the blank tape with a prerecorded one,
e Clean the heads (see page 6).
e Set the amplifier input selector correctly,
e Turn the amplifier volume control up.
e Connect securely (see page 7).
e Replace the cassette with one whose tabs are
intact.
e Cover the hole over the tab (see page 4).
e Turn REC LEVEL control up (see page 19).
e Set the amplifier recording output selector
correctly.
e Check connections (see page 7).
e Record in the opposite direction,
e Rewind the tape,
e Take up the slack (see page 4).
a Clean the head (see page 6).
e Check that the recording and playback connection
cords are connected correctly, (see page 7).
e Set the amplifier selector correctly.
27
<RRE1134>
En