Device; Hdd Set; Ptz Set; System - Monacor AHR-40 Bedienungsanleitung

6.2.6 Device

6.2.6.1 HDD Set

It is an important first step when configuring your DVR
to make sure that the hard drive (HDD) options are
correctly set. So, strongly suggest that you do format
the HDD before start the first record.
Click [Main menu  Device  HDD] to enter into the interface
shown as fig. 6-42.
When DVR is connected to a HDD, the system will automatically
detect if HDD is normal or not. If the cable connected to HDD
is loosen or HDD is abnormal, HDD status will be shown as "No
Disk", or, If HDD need to be formatted, status will be shown as "no
format", otherwise, the HDD status will be shown as "Normal"
No.: Number of the hard disk (selection for formatting in the
column "Select").
Status: It will be available only when HDD have been formatted.
Total Space: Total size of the hard drive currently installed.
Free Space: Total amount of free space available on the hard
drive currently installed.
Useable Rec. Time: Free space currently available in hours.
Auto-overwrite: When set to ENABLE the DVR will record
over the oldest files on the hard drive. The DVR will always be
able to record events as they happen, however, it does means
that you'll need to get important events off the HDD before
they're overwritten; and if overwrite is set to DISABLE the
DVR will stop record once the DVR is full. Whilst you won't
lose old footage, you run the risk of missing new events as
they happen. Be sure you want to do this before selecting it.
HDD Format: Formatting the HDD will erase all data (i. e.
footage) which is stored on it, and re-create the FAT (file al-
location table).
USB Format: If you have a USB flash drive connected to the
DVR, you can format that, too. To do this, click the [USB For-
mat] button and click [OK].

6.2.6.2 PTZ Set

Click [Main Menu  Device  PTZ] to enter into the below
window shown as fig. 6-43.
You could select the channel you desire to control and set PTZ
protocol (Pelco-D or Pelco-P), Baud Rate (1200, 2400, 4800,
9600), Data bit (8, 7, 6, 5), Stop bit (1, 2), Parity Check (None,
Odd, Even, Mark, Space), Address Code and Cruise status
respectively. Please note the PTZ device can be activated only
when a channel in connection with the PTZ camera is selected.
44
Fig. 6-42
Fig. 6-43

6.2.7 System

6.2.7.1 General

Click [Main Menu  System  General] to enter into the
interface shown as fig. 6-44.
You will be allowed to modify system date/time, date/time
format, time zone, language, video format and menu time
out. And click [DST Setup] button to enter into the below
interface shown as fig. 6-45, and you are allow to configure
DST status and mode.
To synchronize the date and the time via the Internet, click the
[NTP Setup] button (NTP = Network Time Protocol).
Note: The above [NTP function] change will be available only when sys-
tem connected to internet. And When NTP function is set to "Enable",
system will calibrate the time at every 00:07:50 and every start-up.

6.2.7.2 Users

Click [Main Menu  System  Users] option and then enter
into the interface shown as fig. 6-47.
The model supports up to seven users with one Admin and six
users. Click [Edit] button to enter into the [User Edit] interface
shown as fig. 6-48. And input user name and password.
Fig. 6-44
Fig. 6-45
Fig. 6-46
Fig. 6-47