Herunterladen Inhalt Inhalt Diese Seite drucken

Dvr Connection; Hdd Installation; Camera And Monitor Connection; Power Supply Connection - Monacor AHR-40 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für AHR-40:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

4

DVR Connection

4.1 HDD Installation

Caution: Please do not install or take out hard drive when
DVR is running!
HDD Installation:
1) Cut power firstly, and then remove screws and open DVR
upper cover carefully;
2) Insert Power Cord and data cable into Pin of hard drive
securely.
3) Remove the screws on the HDD bracket; fix the HDD to the
bracket and then fix the bracket with HDD to DVR body.
4) Put the upper cover back carefully, re-attach screws.
5) Make the settings for the HDD
(chapter 6.2.6.1 on page 44).
Note: If user requires higher performance HDD, strongly recommend
you use special hard driver for security and protection.

4.2 Camera and Monitor Connection

Connect the cameras to video inputs (20) of DVR, and from
video output (24, 25) of DVR to Monitor (refer to chapter 3.2).
If the camera is a PTZ speed dome, you could connect
RS 485 A and B to the according port of DVR respectively.

4.3 Power Supply Connection

Connect the power supply unit to the jack 12 V⎓ (29) and to
a socket (230 V~ /50 Hz).
5

DVR Boot up

5.1 System Initialization

When the recorder is switched on with the rocker switch I / ●
(30) on the rear side, the system will start:

5.2 Live Interface

After finishing initialization the system will enter into <Live>
screen.
36
Fig. 5-1
Fig. 5-2
Figure 5-2 is the 16-split display defaulted by system, which is
showing no video input status. Once there are video inputs,
the screen will display live images from the cameras. In Live
mode, if you use the mouse to double-click the live image of
any channel, the image will be maximized to full screen, by
double-clicking again, image will be come back to 16-split
display mode. Clicking the right button of the mouse will
enter into Pop-up Menu; clicking the left button of the mouse
allows you select menu items; and clicking any area outside
the menu allows you exit the Pop-up menu.
Note: When internal HDD is not connected or an error oc-
curs, the character "H" will appear on the first channel of the
live screen and accompany buzzer alarm (chapter 6.2.8.2 on
page 45).
6
Configuring the Recorder
via the Menu

6.1 Pop-up Menu

After finishing system initialization, click right key of mouse
on main interface mode to enter into Pop-up Menu.
Now you could perform parameter setting and operate on
Main Menu, Multi-Pics, PTZ, Auto Cruise, Zoom in/out, Rec.
Search, Manual record, Sequence, PIP and Mute (buttons from
left to right).

6.2 Main Menu

On <Live> mode, click [Menu] button on the front panel or
Remote controller to enter into Main menu interface shown
as fig. 6-2. And also you can click
menu screen.
In Main Menu mode, you can control device management
settings, such as Display, Record, Network, Search, Device,
System and Advanced setting etc.
Fig. 6-1
icon to enter the main
Fig. 6-2

Werbung

Kapitel

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

18.416018.417018.4180Ahr-80Ahr-160

Inhaltsverzeichnis