Assembly - Parkside PNTS 1400 E2 Originalbetriebsanleitung

GB
• Switch the machine off and pull the
plug under the following circumstances:
- when you are not using the device,
- transporting it or leaving it unat-
tended;
- when you are checking the device,
cleaning it or removing blockages;
- when you are carrying out cleaning
or maintenance work or replacing
accessories;
- when the power or extension cable
is damaged; after contact with for-
eign bodies or in case of abnormal
vibration.
• Never use the mains lead to pull the
plug out of the socket or to pull the
appliance. Protect the mains lead from
heat, oil and sharp edges.
• Make sure that the mains voltage cor-
responds with the information on the
rating plate.
• Only plug the appliance into a socket
which is safeguarded by at least 16 A.
• The device must only be connected to
a mains socket via a residual-current
circuit breaker (RCD) with a rated leak-
age current of not more than 30 mA.
The following states how damage
to the appliance and possible in-
jury to people can be avoided:
• Ensure that the machine is correctly
assembled and the filters are in the cor-
rect position.
• Do not use without the filter. This could
damage the machine.
• Only use Spare parts and accessories
delivered and recommended by our
Service Centre (see "Spare parts/Ac-
cessories"). The use of parts by other
manufacturers immediately renders the
guarantee void.
• Only have repairs carried out at our
authorised customer service points.
8
• Observe the instructions for cleaning
and maintenance of the machine.
• Store the appliance in a dry place and
out of reach of children.

Assembly

Pull out the mains plug.
Danger of electric shock.
The appliance is supplied with the
folded filter (
1. Place the 4 steering castors (11) onto
the mounts on the stainless steel con-
tainer (9). Attach each steering castor
with a crosshead bolt (11a).
2. Push the bow handle (1) onto the two
bow handle tie bars (2) and screw it in
place with 2 crosshead bolts (1a).
3. Place the motor head (3) on the stain-
less steel container (9).
4. Close the stainless steel container by
folding up the bow handle and fixing
it with the locking levers (14). everal
positions are possible for the bow han-
dle.
The locking lever must be tightened so
that a tensioning with medium force
can be carried out. You can set the ten-
sion by turning the locking lever:
- Tighten: turn clockwise
- Loosen: turn anti-clockwise.
5. Place the carrying handle (4) on the
motor head (3) and screw it on tight
with 2 crosshead screws (4a).
6. Fit the accessories:
- Connect the suction hose (19).
- Fit the handle (20)
- Fit the telescopic suction pipe (17).
(Press the knob on the telescopic suc-
tion pipe in the
separate to the desired length).
- Fit the desired nozzle (25/26).
23) fitted.
direction and