Interrupting Operation; Ending Operation; Using Detergents - Parkside 270433 Originalbetriebsanleitung

The standard Vario nozzle is set to high
pressure by default.
Push the tip of the nozzle forward to
change to low-pressure operation.
In this mode (low pressure), the unit will
automatically draw in cleaning agent from
the built-in tank (cf. "Using detergents").
Push in the tip of the nozzle to change to
high-pressure operation.
• Lock / unlock the starting lever
B
(25) of the gun (1) by depressing
the locking knob (24).
Lock the starting lever (25) to
prevent the pressure cleaner
from being inadvertently / ac-
cidentally started.
Locked
Open

Interrupting operation

• Release the lever of the gun (1).
• During prolonged work intervals turn
off the pressure cleaner by its ON /
OFF switch (10).
If the equipment falls over,
switch off the equipment
immediately at the on/off
switch (6) and disconnect the
equipment from the mains at
the mains power cord.
of electric shock!
should the equipment be re-
turned to an upright position.
For your own safety, wait
approx. 5 minutes before re-
connecting to the electricity.

Ending operation

1. After having worked with a detergent
2. Release the lever of the gun (1).
3. Turn off the pressure by its ON / OFF
4. Turn off the water tap.
5. Disconnect the pressure cleaner from
6. Pull the lever of the gun (1) to vent the

Using detergents

The pressure cleaner was designed for
operation with a neutral detergent based
on a biologically decomposable anionic
tenside. Other detergents or chemical sub-
stances could impair the safety of the pres-
sure cleaner and damage it. Such damage
to the equipment is not covered by the
guarantee.
Fill/drain detergent:
•
•
Risk
Only now
•
Working Instructions:
•
rinse the pressure cleaner with clear
water.
switch (6). Disconnect the mains plug.
the water mains.
pressure existing within the system.
To add cleaning agent to the jet, you
must first fill the cleaning agent tank
(17).
To remove the cleaning agent tank
(17), hold it on the side and push it up-
wards. You can now pull the cleaning
agent tank out of the bottom and side
guides on the pressure cleaner. Mind
to first remove the induction hose and
the cap from the opening of the clean-
ing agent tank (16) as they will remain
on the pressure cleaner.
To reinstall the cleaning agent tank
(17), trace back the above steps.
Operate the standard Vario nozzle
(19) in low-pressure mode to automati-
cally add cleaning agent to the water.
GB
39