Operational Setup; Introduction; Setting The Address; Parameters - Honeywell proX1 Montageanleitung Und Bedienungsanleitung

14
6

Operational setup

6.1

Introduction

Each reader operated on the RS-485 bus must have a
system prevents addresses from being assigned multiple times.
Available address range:
The assignment of addresses takes place using the DIP switches 1 - 5.
A change of the DIP switch settings only takes effect after the operating voltage is applied.
In case you change the setting during ongoing operation, interrupt the operating voltage
briefly afterward.
6.2

Setting the address

Each reader operated on the RS-485 bus must have a
can be set with the DIP switches 1 to 5. Take care that no address is assigned multiple times.
6.3

Parameters

Additional parameters are programmed via the access control unit and are thus application-
dependent. Depending on the connection to an access controller, the two programs IQNetEdit and
IQ MultiAccess are used, or if connected to an IDCU the associated WINFEM program in each case.
The mode of function is always to be set to PIN plus.
6.4

LED display

The LEDs of the reader and the buzzer function are governed by the accessed control unit.
Depending on the control unit used, the functions are pre-assigned or can be programmed.
Mounting and connection instructions for readers with scrambling keypad
dependent on the access control unit used.
yellow green
unique address . A
unique address . The reader addresses 0 to 31
Operating
mode
No function
16
8
4
2
1
Value
Example: Address 5
red
plausibility check in the
Address
ON