JVC KD-AVX55 Bedienungsanleitung Seite 26

Menu item
Fader/Balance
Fader:
Adjust the front and rear
speaker output balance.
Balance:
Adjust the left and right
speaker output balance.
Volume Adjust * 1
Subwoofer Level
High Pass Filter
Crossover
Amplifier Gain * 2
Rear Speaker * 3
* 1
For "DISC/USB": You can make the adjustments separately depending on the audio format—Dolby digital and
the others.
* 2
The volume level automatically changes to "30" if you change to <Low Power> with the volume level set higher
than "30."
* 3
This setting takes effect only when Dual Zone is activated. (
24
♦
F06 to R06; Initial 00 (fader)
♦
L06 to R06; Initial 00 (balance)
5 ∞
[ / ]: Adjusts fader.
2 3
[ / ]: Adjusts balance.
[ ]: Resets the adjustments.
• When using a two-speaker system, set the fader to the center (00).
Adjust and store the auto-adjustment volume level for each source, comparing
to the FM volume level. The volume level will automatically increase or decrease
when you change the source.
• <Fix> appears when an FM broadcast is selected as the source.
♦
–12 to +12; Initial 00
You can adjust the output level of the subwoofer when it is activated.(
♦
–06 to +08; Initial 00
♦
Through : Select when the subwoofer is not connected.
♦
On : Select when the subwoofer is connected.
Select the crossover frequency between the front/rear speakers and the
subwoofer.
♦
80Hz, 120Hz, 150Hz
You can change the maximum volume level of this unit.
♦
Off : Deactivates the built-in amplifier.
♦
Low Power : VOL 00 to 30 (Select this if the maximum power of the
speakers is less than 50 W.)
♦
High Power : VOL 00 to 50
You can activate/deactivate the rear speakers.
♦
Off, On
Selectable setting/item
43)
Initial: Underlined
Dragging also makes
adjustments.
17)