Installation Using The Screw Holes On The Side Of The Unit - Pioneer AVH-3200BT Installationsanleitung

Installation
2. Install this unit and fasten the screws.
Dashboard
Screw (3 × 6 mm)
(Supplied with this unit)
3. Attach the trim ring.
Trim ring
(Supplied with this unit)
Installation using the screw
holes on the side of the unit
1. Remove the side brackets.
14
Rubber bush
(Supplied with this unit)
Double-ended screw
(Supplied with this unit)
Side bracket
(Supplied with this unit)
Screw for fixing the side
bracket (5 × 9 mm)
(Supplied with this unit)
2. Fastening the unit to the factory
radio-mounting bracket.
Position the unit so that its screw holes are
aligned with the screw holes of the bracket,
and tighten the screws at 3 or 4 locations on
each side.
Factory radio mounting bracket
Tapping screw
(5 mm × 8 mm)
Note
In some types of vehicles, discrepancy may
occur between the unit and the dashboard. If this
happens, use the supplied frame to fill the gap.
If the pawl gets in the way,
bend it down.
Dashboard or console