Attaching/Disconnecting The Battery Pack To/From The Appliance; Checking The Battery Charge Level; Checking The Blade Guard; Initial Use - Parkside PHKSA 18-Li B2 Originalbetriebsanleitung

♦ Insert the mains plug into the mains power socket.
The red control LED
♦ The green control LED
charging process is complete and the battery
pack is ready.
♦ Insert the battery pack
ance.
GB ■ Never recharge a battery pack
immediately after rapid charging. This could
overcharge the battery pack
the lifespan of the battery and charger
♦ Switch off the charger
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦ Allow the battery pack
handle.
Removing the battery pack:
♦ Press the release button
battery pack

Checking the battery charge level

♦ Press the battery charge level button
check the status of the battery (see also main
diagram). The status/remaining charge will be
shown on the battery display LED
♦ RED/ORANGE/GREEN = maximum charge/
power
RED/ORANGE = medium charge/power
RED = low charge – charge the battery

Checking the blade guard

♦ Pull back on the release lever for the blade
guard as far as the stop.
The blade guard
ming and must spring back into its starting position
automatically when you let go of the release lever
for the blade guard
36
lights up.
indicates that the
back into the appli-
again
, thus reducing
for at least 15 minutes
to click into the
and remove the
.
as follows:
must move freely without jam-
.

Initial use

Fitting/changing the saw blade

Always remove the battery pack before changing
the saw blade
1. Set the cutting depth (using the locking screw
to the minimum position, 0 mm.
2. Swing the blade guard
release lever
3. Press the spindle lock button
and use the Allen key
.
screw
and the clamping flange
Fig. A Changing the saw blade
4. Remove
5. Fitting a saw blade
order.
6. Press the spindle lock button
to
and use the Allen key
screw
WARNING!
► The arrow on the saw blade
spond to the arrow showing the direction
of rotation (running direction shown on the
appliance).
■ Ensure that the saw blade
rotational speed of the tool.

Rip fence

♦ Loose the wing screw
fence
♦ Set the desired cut width with the help of the
scale on the rip fence
base plate
The right-hand recess in the base plate is for a
cutting angle of 0°. The left-hand recess in the
base plate is for a cutting angle of 45°.
!
back using the
and put the appliance down.
(until it engages)
to release the clamping
. Now remove the clamping screw
(see also Fig. A).
saw blade.
is carried out in the reverse
(until it engages)
to tighten the clamping
.
is suitable for the
and insert the rip
into the rip fence slot
and the cut out in the
(see also Fig. B).
PHKSA 18-Li B2
)
must corre-
.