General Power Tool Safety Warnings; General Instructions For Hot Air Blowers - Parkside PHLG 2000 C2 Originalbetriebsanleitung

General Power Tool
Safety Warnings
WARNING!
Read all safety warnings and all
►
instructions. Failure to follow the
warnings and instructions may
result in electric shock, fire and/
or serious injury.
Save all warnings and instructions
for future reference.
The term "power tool" in the warnings
refers to your mains-operated (corded/
mains adapter) power tools or battery-
operated (cordless) power tool.
Do not expose power tools to rain
■
or wet conditions. Water entering
a power tool will increase the risk
of electric shock.
Do not abuse the cord. Never use
■
the cord for carrying, pulling or
unplugging the power tool. Keep
cord away from heat, oil, sharp
edges or moving parts. Damaged
or entangled cords increase the risk
of electric shock.
If operating a power tool in a
■
damp location is unavoidable, use
a residual current device (RCD)
protected supply. Use of an RCD
reduces the risk of electric shock.
Do not use the power tool if the
■
switch does not turn it on and off.
Any power tool that cannot be con-
trolled with the switch is dangerous
and must be repaired.
PHLG 2000 C2
General instructions for hot air
blowers
This appliance may be used by
■
children aged 8 years and above
and by persons with limited physi-
cal, sensory or mental capabilities
or lack of experience and know-
ledge, provided that they are under
supervision or have been told how
to use the appliance safely and are
aware of the potential risks.
Children must not use the appliance
as a plaything. Cleaning and user
maintenance tasks may not be car-
ried out by children unless they are
supervised.
To avoid potential risks, if the appli-
■
ance power cord is damaged it must
be replaced by the manufacturer, its
customer service or by a qualified
technician.
Have your power tool serviced by
■
a qualified repair person using
only original replacement parts.
This will ensure that the safety of
the power tool is maintained.
Plugs and power cords should only
■
be replaced by the manufacturer
of the power tool or the manufac-
turer's authorised customer service
agent. This will ensure that the safety
of the power tool is maintained.
GB
19