General Safety Information For Electrical Devices; Product-Specific Safety Instructions - Parkside PKZ 180 A1 Originalbetriebsanleitung

General safety instructions ... / General safety information for electrical devices
Disconnect the compressed air unit from the air
supply after each use and when not in use. Do
not use the compressed air unit if it leaks or is
in need of repair.
Keep your working area clean and well lit.
Untidy or poorly lit working areas can result in
accidents. Doing so will allow you better con-
trol of the device, particularly under unforeseen
circumstances.
Only have the device repaired by qualified
specialist personnel using OEM spare parts.
This will maintain the safety of the device.
Keep children and other persons away from
the device during use. Distractions can cause
you to lose control of the device.
Wear suitable clothing. Do not wear loose
clothing or jewellery. Keep your hair, clothing
and gloves clear of moving parts. Loose cloth-
ing, jewellery or long hair can become trapped
in moving parts.
Put down trigger and device in the event of
unexpected compressor failure.
If possible, use a condensate trap or drain the
hoses and pipes of condensate (water) regu-
larly before and during the use compressed air
units.
ATTENTION! An undersized compressed air
system may minimise the efficiency of your
device.
Never point the compressed air unit at yourself,
other persons or animals. Otherwise there is a
risk of injury.
Always observe all the safety notices attached
to the compressor.
Make sure that the compressor intake opening
is never blocked and the airflow is never hin-
dered.
Switch off the device and pull the plug from the
socket to prevent it from being accidentally
switched on.
Do not allow yourself to become distracted
while working with the device.
Never operate the compressor in temperatures
below 5 degrees.
The outlet must always be within reach.
106630_Kompressor_PKZ_180_A1_content_IT.indd 19
ATTENTION! The pressure gauge is not cali-
brated! Please check the air pressure with a
calibrated device after filling.
General safety information
for electrical devices
Always connect the device to a residual current
(FI) protective switch.
Protect yourself against electric shock. As you
are working, avoid touching grounded parts
(e.g. refrigerator, water supply pipes etc.).
DANGER OF ELECTRIC SHOCK! Avoid
contact with live lines. This device is not insu-
lated against electric shock.
Regularly check extensions and power supply
cables. Replace any faulty cables with new
ones immediately. If the supply cable of this
device is damaged, it must be replaced by the
manufacturer or its service department, or a
similarly qualified person in order to avoid haz-
ards.
Store the device in a dry environment when it is
not being used over a longer period.
Make sure that the connection cable does not
hang over a corner or be stretched; otherwise
there is a risk of injury.
Do not use the mains lead for any purpose for
which it was not intended, e.g. to carry the
product, to hang it up or to pull the mains plug
out of the mains socket.
Never use power tools in damp or wet environ-
ments, and never expose it to rain or high hu-
midity.
Never switch on the device in the vicinity of
inflammable liquids or gases. If the device is
used outdoors, only use extension cables that
are expressly designed for outdoor use.
Product-specific safety
instructions
CAUTION! HOT SURFACE! The compressor
heats up after extended operation. Therefore
GB/MT 19
02.12.14 08:48