Sawing; Sanding; Scraping; Cleaning/Maintenance - Parkside PKGA 16 A1 Betriebsanleitung

GB I E N I
Wear ear protection.

Sawing

Wear eye protection.
• Use only undamaged sawblades in
perfect condition. Only use metal saw-
blades for metalworking.
• Ensure your stance is stable and hold
the appliance tightly with both hands
and away from your body.
• Before sawing the workpiece, check
for hidden foreign objects such as
nails, screws. These must be removed.
• Plunge cuts may only be made in soft
material such as wood or plaster-
board.
Selection of sawblade
Wood sawblade
Metal sawblade
Plunge sawblade

Sanding

• Use a dust extraction system when sand-
ing with the multi-sander attachment.
• Move the appliance against the work-
piece once it is switched on.
• Clean the sanding plate before you at-
tach a sanding sheet.
• Only work with sanding sheets in per-
fect condition to achieve good sanding
results.
• Work using low and even pressure.
This protects the appliance and the
sanding sheet.
1 8
CY
for wood, plastic, plaster-
board
for metal sheets, profiles
and tubes
for soft materials like
wood or plasterboard
• Do not use the same sanding sheet to
sand different materials (e.g. metal
and then wood).
Selection of sanding sheet
Grain size P Application
for pre-sanding rough wood
60
surfaces
80 / 120 for plain sanding
for fine sanding of primed and
240
painted surfaces

Scraping

• Use a high oscillation rate when scrap-
ing.
• Work using low pressure and at a low
angle in order not to damage the sub-
strate material.

Cleaning/Maintenance

Repair and servicing work not
described in this manual should
always be carried by our Service
Centre. Use only original parts.
Switch off the device and remove
the battery from the device before
working with or transporting it.
The following cleaning and servicing
should be done regularly. This will ensure a
long and reliable service life.