Part Names And Functions; Front Panel And Controls - Yamaha DPX-1000 Bedienungsanleitung

Part Names and Functions

I Front panel and controls
Front remote control sensor
Ventilation (Exhaust) vent
Lens cover
1 STANDBY/ON indicator
2 STANDBY/ON button
Switches the unit between Standby and On (operational)
modes.
3 ESCAPE button
Use this button to exit from submenu mode.
4 PATTERN button
Switches the built-in test pattern display on and off.
5 ASPECT button
Selects the display aspect of the projection image. Press the
button to display the aspect presently being used. Pressing the
button again within 2 seconds will switch the unit to the next
aspect mode.
6 LAMP warning indicator
7 COVER warning indicator
2
E-
Lens
Adjuster
Use this to make fine adjustments
to the projection angle.
STANDBY/ON indicator
1 STANDBY/ON
2
3
ESCAPE MENU
4
PATTERN
5
ASPECT INPUT
LAMP COVER TEMP FAN
6
DIGITAL CINEMA PROJECTOR DPX-1000
7
8
(Enter) button
Press this button to set values and enter into submenus.
9 MENU button
Press this button to display the general settings and adjustments
menu.
0 SETTING button
Selects the various lens adjustment modes.
q INPUT button
Press this button to display the input source and input signal
selection menu.
w Cursor button
Use the h, g, –, + buttons for functions such as system
operations, menu item selection, and changing system values.
e FAN warning indicator
r TEMP warning indicator
Lamp cover
Ventilation inlet
8
9
0
SETTING
q
w
e
r