Yamaha YST-SW45 Bedienungsanleitung Seite 5

Using two units
Disconnect your main speakers from the amplifier if connected, and connect them to the speaker terminals of this unit.
Right speaker
This unit
OUTPUT INPUT2 AUTO
TO SPEAKERS STANDBY
LOW HIGH
OFF
FROM AMPLIFIER
INPUT1
POWER
ON
OFF
To AC outlet
Connecting to this unit's OUTPUT/INPUT terminals
For connections, keep the speaker wires as short as possible.
(Cut the excessive wire, if necessary.) If the connections are faulty,
no sound will be heard from the speakers. Make sure that the
polarity of the speaker wires is correct, by observing + and –
markings. If these wires are reversed, the sound will be unnatural
and will lack bass.
Do not let the core of the speaker wires touch each other
and do not let them touch the metal parts of this unit as this
could damage this unit, your amplifier and/or speakers.
How to Connect:
Red: positive (+)
Black: negative (–)
OUTPUT INPUT2 AUTO
STANDBY
TO SPEAKERS
LOW HIGH
OFF
FROM AMPLIFIER
INPUT1
Speaker terminals
1 Unscrew the knob.
2 Insert the core of the
wire. [Remove
approx. 5 mm (1/4")
insulation from the
speaker wires.]
3 Tighten the knob to
secure the wire firmly.
OUTPUT INPUT2 AUTO
STANDBY
TO SPEAKERS
LOW HIGH
OFF
FROM AMPLIFIER
INPUT1
Amplifier
* Banana Plug connections are also possible (except for U.K.
and Europe models). Simply insert the Banana Plug con-
nector into the corresponding terminal.
Left speaker
This unit
OUTPUT INPUT2 AUTO
TO SPEAKERS STANDBY
LOW HIGH
OFF
FROM AMPLIFIER
INPUT1
POWER
ON
OFF
To AC outlet
5