Operation; Turning The Power On; Turning The Power Off; Playback - Pioneer PLX-1000 Bedienungsanleitung

Operation

Turning the power on

1 Make all the connections, then plug the power cord
into a power outlet.
Connections (p. 10 )
2 Change the [POWER] switch to the [ON] side to turn
on the power of the unit.
This unit's indicators light and the power turns on.

Turning the power off

Change the [POWER] switch to the [OFF] side to turn off
the power of the unit.
This unit's power turns off.

Playback

Prepare as follows.
Place a record on the turntable.
Remove the stylus cover and arm clamper.
1 Change the [POWER] switch to the [ON] side to turn
on the power of the unit.
2 Press the [START/STOP] button.
The turntable rotates.
3 Press the [RESET] button.
The [RESET] indicator lights in yellow-green and the speed returns to the
prescribed rpm (33 1/3 or 45 rpm).
4 Pull up the lifter lever and move the tone arm onto
the record.
5 Push down the lifter lever.
The tone arm slowly descends and playback begins.

Pausing playback

Pull up the lifter lever.
The stylus of the cartridge lifts away from the record.
To resume playback, push down the lifter lever.

Finishing playback

1 Pull up the lifter lever to return the tone arm to the
arm rest and then push down the lifter lever.
2 Press the [START/STOP] button.
An electronic brake brings the turntable to a smooth stop.
3 Change the [POWER] switch to the [OFF] side to turn
off the power of the unit.
Use the arm clamper to secure the tone arm.
To protect the stylus tip, attach the stylus cover.
12
En
About the slip mat and slip sheet
Slip mat
If you use the mat instead of the turntable sheet, you can stop the record
by hand during playing, or turn the turntable in reverse.
Slip sheet
When the slip sheet is used under the slip mat, sliding of scratch
becomes smooth.
To play a standard EP record
Attach the EP record adapter to the center spindle and press the [45]
button.
Illuminating the stylus tip
When the stylus illuminator switch is pressed, the stylus illuminator
lights in white and ascends to the position at which the stylus tip is
illuminated.
If it is not needed, press the stylus illuminator switch to lower it. The
stylus illuminator switch goes off.
Attaching the dust cover
When you are done using the unit, hold both sides of the dust cover and
place from directly above.
Slip mat
Slip sheet