Display Menu - Yamaha YSP-500 Bedienungsanleitung

MANUAL SETUP

DISPLAY MENU

Use to manually adjust the various parameters related to
the display.
SET MENU → MANUAL SETUP → DISPLAY MENU
4)DISPLAY MENU
.
A)F.DISPLAY SET
B)OSD SET
C)UNIT SET
[ ]/[ ]:Up/Down
[ENTER]:Enter
F.DISPLAY SET
(Front panel display settings)
Use to adjust the brightness and display settings of the
front panel display.
A)F.DISPLAY SET
.
STANDARD DIMMER;;;;;OFF
AUTO DIMMER
;;;;;;;;;;;;;OFF
[ ]/[ ]:Up/Down [ ]/[ ]:Sel
[ENTER]:Return
STANDARD DIMMER (Standard dimmer)
Use to adjust the brightness of the front panel display
when you operate this unit by using the control buttons on
the front panel or on the remote control.
Choices: –2, –1, OFF
AUTO DIMMER (Auto dimmer)
If no operation is performed for a specified period of time,
the front panel display dims. Use to adjust the brightness
of the front panel display in this case.
Choices: OFF (the same brightness as the STANDARD
DIMMER setting), –1 to –3 (based on the
STANDARD DIMMER setting), DISPLAY OFF
66
En
p
OSD SET (OSD settings)
Use to adjust the display position and to set the display
time of the OSD.
B)OSD SET
OSD SHIFT;;;;;;;;;;0
p
[ ]/[ ]:Select
[ENTER]:Return
OSD SHIFT (OSD shift)
Use to adjust the vertical position of the OSD. Adjust
toward the – (minus) direction to raise the position of the
OSD, and adjust toward the + (plus) direction to lower it.
Choices: –5 to +5
Initial setting: 0
UNIT SET (Unit settings)
Use this to change the display unit of measurement.
Choices: METERS, FEET
C)UNIT SET
p
METERS
p
[ ]/[ ]:Select
[ENTER]:Return
• Select METERS to enter distances in meters.
• Select FEET to enter distances in feet.
Note
If you change this setting, the adjusted sound beam settings may
change.
FEET