Yamaha YID-W10 Bedienungsanleitung Seite 6

3: Playback
1 Connect your iPod/iPhone to the
transmitter.
The green LED on the transmitter (YIT-W11TX)
and blue LED on the receiver (YIR-W10) light up
if a wireless connection between the transmitter
and receiver is established.
Transmitter LED status
LED
Lights up green
Flashes green once
Flashes green continuously
Flashes red once
Flashes red for 2 seconds
Flashes red continuously
Flashes red 2 times continuously The battery of the iPod/iPhone is low.
Off
Receiver LED status
LED
Lights up blue
Flashes blue once
Flashes blue
Flashes blue rapidly
Off
4
En
Status LED
Status LED
Wireless communication between the transmitter and receiver is
established.
Adjusting the volume level.
Connection in progress, please wait.
The volume of Yamaha component is set to maximum or
minimum.
An unsupported iPod is connected.
Error occurs. Remove the iPod/iPhone from the transmitter, and
connect again.
An iPod/iPhone is not connected or wireless communication has
not been established.
Wireless communication between the transmitter and receiver is
established.
Adjusting the volume level.
Connection in progress, please wait.
Error occurs. The receiver is in need of repair.
An iPod/iPhone is not connected or wireless communication has
not been established.
2 Start playback on your iPod/iPhone.
Operation and function depend on your iPod/
iPhone model and Yamaha component. Refer to
the owner's manuals supplied with your iPod/
iPhone and Yamaha component.
Notes
• In case noises are output from the speaker, place
the receiver away from your Yamaha component.
• The transmitter is powered by the battery of your
iPod/iPhone. When your battery of iPod/iPhone
becomes empty, charge your iPod/iPhone.
y
• The transmitter stops wireless communication
automatically after a short time you stop iPod/
iPhone playback.
• To disconnect the iPod/iPhone from the
transmitter, pull it upward.
Status
Status