Using Alarm; Setting The Alarm; Switching Alarm Mode; When Alarm Sounds - Pioneer X-DS301-K Bedienungsanleitung

Setting The Alarm

Set the alarm time under STANDBY mode (Turn the power off)
1. Press and hold
mode.
2. The "Minute" of the alarm time on the display starts to blink.
[System] Press
[Remote] Press
3. Press FUNC again to adjust "Hour".
[System] Press
[Remote] Press
4. The display will show "END" when alarm time set is complete.

Switching Alarm Mode

[Remote] Press
sound) d iPod d FM d Alarm off sound
[System] When the system is in STANDBY mode, press and hold
between different alarm sounds: BUZZ (default sound) d iPod d FM d Alarm off sound

When Alarm Sounds

1. Press SNOOZE on the remote, the alarm will stop and re-sound every
10 minutes.
2. Press POWER to turn off the alarm.

Setting The Clock

Set the clock time under STANDBY mode. (Turn the power off)
1. After the alarm time set is complete, press
2. The "Minute" of the clock time on the display starts to blink.
[System] Press
[Remote] Press
3. Press FUNC again to adjust "Hour".
[System] Press
[Remote] Press
4. The display will show "END" when clock time set is complete.

Using Alarm

FUNC (on either system or remote control) to enter alarm setting
Volume +/ Volume – to adjust the time.
Up/ Down to adjust the time.
Volume +/ Volume – to adjust the time.
Up/ Down to adjust the time.
Alarm Mode to switch between different alarm sounds: BUZZ (default
Volume +/ Volume – to adjust the time.
Up/ Down to adjust the time.
Volume +/ Volume – to adjust the time.
Up/ Down to adjust the time.
FUNC to enter clock time set.
15
Power to switch