Herunterladen Inhalt Inhalt Diese Seite drucken

Mounting/Dismounting The Saw Blade Guard; Replacing The Table Insert; Adjusting/Mounting The Riving Knife - Parkside PTK 2000 B2 Originalbetriebsanleitung

Vorschau ausblenden Andere Handbücher für PTK 2000 B2:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

4. Release the two attachment bolts (30)
and insert the riving knife (4) between
the metal plate and the mount (see
Figure 18).
5. The distance between the saw blade
and riving knife (4) should be between
3 mm and max. 8 mm, (Figure 19).
6. Retighten the attachment bolts (30)
and mount the table insert (6) (see
Figure 17).
Mounting / dismounting
the Saw Blade Guard
(Figures 20/21)
1. Before initial assembly, the batteries
of the laser have to be inserted (see
Mounting the Riving Knife 1).
2. Dismantle the bolt with wing nut and
shim (27) of the saw blade guard (2).
Place the saw blade guard (2) from
the top onto the riving knife (4).
3. Mount the bolt with the wing nut and
shim (27) so that the bolt sits firmly in
the slot (28).
4. Do not overtighten the bolt (27). The
saw blade guard must be able to
move freely.
5. Place the suction hose (3) on the
suction adapter (16) and the suction
connector of the saw blade guard (2).
Connect a suitable woodchip extrac-
tion system to the suction adapter (16),
(Figure 21).
6. Dismantling is carried out in reverse
order. Caution! Before you start sa-
wing, the saw blade guard (2) has to
be lowered onto the item being sawn.

Replacing the Table Insert

(Figures 17 and 22)
1. If it is worn or damaged, the table in-
sert (6) has to be replaced, as otherwi-
se there is an increased risk of injury.
2. Remove the 3 countersunk screws (29).
3. Take out the worn table insert (6).
4. The new table insert is mounted in
reverse order.
Adjusting / mounting the
Riving Knife
(Figures 16-19)
Caution!
Remove the mains plug! The setting
of the saw blade (5) must be che-
cked whenever a blade has been
replaced.
1. Adjust the saw blade (5) to the max.
cutting depth, move to the 0° position
and lock in place.
2. Dismantle the saw blade guard (2)
3. Take out the table insert (6).
4. Loosen the attachment bolts (30).
5. Push the riving knife (4) upwards.
6. The distance between the saw blade
(5) and riving knife (4) should be max.
8 mm. (Figure 19)
7. Retighten the attachment bolts (30)
and mount the table insert (6).
8. Reattach the saw blade guard (2).
G B
1 9

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis