Display Symbols; Carrying Out Measurements; Taking Measurements - VOLTCRAFT VC-86 Bedienungsanleitung

Display symbols

AC alternating size for voltage and current
DC direct size for voltage and current
Momentary measuring range is maintained; no "auto-
matic neasuring range selection"
stands for data hold; the measuring figure is kept (e.g.
H
for the record) until the "DH" button is or the multime-
ter is switched off.
OL stands for overload; the measuring range has been
exceeded
Battery replacement symbol; please replace the batte-
ries immediately to avoid measuring errors!
Symbol for the diode test
Symbol for the acoustic continuity tester
Display of the measuring figure al analogeue bar display
(only VC-86)

Carrying out measurements

Never exceed the max. permitted input volumes in
the overvoltage categories II or III (domestic and
commercial area).
The frequency of the change volumes may not
exceed 400 Hz!
Do not touch any circuits or circuit parts if voltages
greater than 25 V ACrms or 35 V DC could be pending
there! Danger to life!
30