Parkside PTBM 500 C3 Betriebsanleitung Seite 9

tion and collection devices, make sure that
these are connected and properly used.
• Do not use the cable for purpo-
ses for which it is not intended.
Do not use the cable to pull the plug
from the socket. Protect the cable from
heat, oil and sharp edges.
• Secure the workpiece. Use jigs or
a vice to hold the workpiece securely.
This is safer than using your hand.
• Avoid abnormal body postures.
Ensure secure footing and keep your
balance at all times.
• Maintain tools with care
- Keep cutting tools sharp and clean
for better and safer working.
- Follow the instructions for lubrica-
tion and changing tools.
- Regularly check the connection
cable of the power tool and, if it is
damaged, have it replaced by a
qualified specialist.
- Check extension cords periodically
and replace them if they are damaged.
- Keep handles dry, clean and free
from oil and grease.
• Remove the plug from the mains
socket when the power tool is not in use,
before maintenance and when changing
tools such as saw blades, drill bits, cutters.
• Do not allow any tool keys to
remain inserted. Check, before swit-
ching on, that keys and adjusting tools
have been removed.
• Avoid unintentional starting. Make
sure that the switch is off when inserting
the plug into the socket.
• Use extension cables outdoors.
Only use approved and appropriately
marked extension cables outdoors.
• Pay attention at all times. Pay atten-
tion to what you are doing. Work using
common sense. Do not use the power tool
if you cannot concentrate.
• Check the power tool for possible
damage
- Before further use of the power tool,
safety devices or slightly damaged
parts must be carefully examined in
respect of their proper and intended
function.
- Check that the moving parts are
working properly and are not jam-
med or whether parts are damaged.
All parts must be correctly fitted and
satisfy all conditions to ensure the
proper operation of the power tool.
- Damaged safety equipment and
parts must be repaired properly or
replaced by an authorised specialist
workshop unless otherwise indica-
ted in the instructions.
- Damaged switches must be repla-
ced at a customer service work-
shop.
- Do not use power tools if the switch
cannot be turned on and off.
• CAUTION! The use of other bits and
other accessories can result in a risk of
personal injury.
• Have your power tool be repaired
by a qualified electrician
- This power tool complies with the relevant
safety regulations. Repairs may only be
performed by a qualified electrician,
using original spare parts; otherwise acci-
dents involving the user may result.
Service:
• Have your power tool repaired
only by qualified specialists and
only with original spare parts. This
will ensure that the power tool remains
safe.
GB
9