Practical Tips; Sawing; Sanding; Scraping - Parkside PKGA 14.4 A1 Betriebsanleitung

GB

Practical tips

When working with the ap-
pliance, always wear suitable
clothing and appropriate pro-
tective equipment.
Prior to each use it must be
ensured that the appliance is
working correctly.
Personal protective equipment
and a fully functional appli-
ance reduce the risk of inju-
ries and accidents.

Sawing

Wear eye protection.
• Use only undamaged sawblades in
perfect condition. Only use metal saw-
blades for metalworking.
• Ensure your stance is stable and hold
the appliance tightly with both hands
and away from your body.
• Before sawing the workpiece, check for
hidden foreign objects such as nails,
screws. These must be removed.
• Plunge cuts may only be made in soft
material such as wood or plasterboard.
Selection of sawblade
for wood, plastic, plaster-
Wood sawblade
board
for metal sheets, profiles
Metal sawblade
and tubes
for soft materials like
Plunge sawblade
wood or plasterboard
18

Sanding

• Use a dust extraction system when
sanding with the multi-sander attach-
ment.
• Move the appliance against the work-
piece once it is switched on.
• Clean the sanding plate before you at-
tach a sanding sheet.
• Only work with sanding sheets in per-
fect condition to achieve good sanding
results.
• Work using low and even pressure.
This protects the appliance and the
sanding sheet.
• Do not use the same sanding sheet to
sand different materials (e.g. metal
and then wood).
Selection of sanding sheet
Grain size P Application
for pre-sanding rough wood
60
surfaces
80 / 120 for plain sanding
for fine sanding of primed and
240
painted surfaces

Scraping

• Use a high oscillation rate when scrap-
ing.
• Work using low pressure and at a low
angle in order not to damage the sub-
strate material.