Recharging The Battery; Used Batteries; Checking The Charge Status Of The Rechargeable Battery; Operation - Parkside PKGA 14.4 A1 Betriebsanleitung

GB
2. To insert the battery (9) push the
battery along the guide rail into
the appliance. It locks into place
audibly.

Recharging the battery

1. Remove the battery (9) from the
appliance.
2. Slide the rechargeable battery (9)
onto the charger (15). It locks into
place audibly.
3. Plug the charger (15) into an elec-
trical outlet.
4. After the charging process, dis-
connect the charger (15) from the
mains supply.
5. Pull the rechargeable battery (9)
out of the charger (15).
Overview of the LED indicators
(15a) on the charger (15):
green LED flashes:
Charger is connected to the
mains without a battery.
red LED lights up:
Battery charging.
green LED lights up:
Battery is charged.

Used batteries

• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to be
replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
• Always take heed of the applicable
safety instructions as well as the envi-
14
ronmental protection regulations and
information (see "Waste Disposal and
Environmental Protection").
Checking the charge status of
the rechargeable battery
The battery charge status indicator (9a)
signalises the state of charge of the battery
(9).
Press the button (9b) on the battery
(9). The state of charge of the bat-
tery is displayed by illuminating the
3-colour LED lights of the state of
charge display (9a).
All LEDs are on: Battery is fully
charged.
Red and yellow LEDs are on: Battery
has a residual charge (< 90 %).
Red LED lights up: Battery is empty,
please charge.

Operation

Replacing the appliance at-
tachment
Secure the appliance against
switching on (see "Switch-
ing on/off") or remove the
rechargeable battery from
the appliance. There is an
injury hazard if the device is
switched on accidentally.
Wear safety gloves. The appliance
attachment might have heated up
after use.
Removing appliance attachment
1. Push the unlocking lever (5) into Push the unlocking lever (5) into
position
and then hold it in this position.
as far as the stop