Additional Safety Instructions - Parkside PKGA 14.4 A1 Betriebsanleitung

Risk of fire and explosion. This
ensures that the safety of the de-
vice is maintained.
• Before each use, check the
charger, cable and plug
and have them repaired
by qualified profession-
als and only with original
parts. Do not use a defec-
tive charger and do not
open it up yourself. This
ensures that the safety of the de-
vice is maintained.
• Connect the charger only
to a socket with an earth.
Ensure that the mains volt-
age matches the specifica-
tions on the charger rating
plate. Risk of electric shock.
• Disconnect the charger
from the mains before
closing or opening connec-
tion to the battery / pow-
er tool / device. This ensures
that the battery and charger are
not damaged.
• Keep the charger clean
and away from wet and
rain. Do not use the charg-
er outdoors. Dirt and the en-
try of water increase the risk of
electric shock.
• Operate the charger only
with the appropriate origi-
nal batteries. Charging other
batteries may result in injuries
and risk of fire.
• Avoid mechanical damage
to the charger. This can result
in internal short circuits.
• Do not operate the charg-
er on a combustible sur-
face (e.g. paper, textiles).
Risk of fire due to heating dur-
ing charging.
• If the power cable for this
equipment is damaged, it
must be replaced by the
manufacturer, a customer
service agent of the same
or a similarly qualified
person in order to prevent
hazards.
• Do not charge non-re-
chargeable batteries in the
charger. This could damage
the appliance.

Additional safety instructions

Warning! Sawing or sanding
can result in the formation of
hazardous dusts (e.g. arising
from materials with paints
containing lead, materials
containing asbestos, metals
or some wood types) which
can present a hazard to the
operator or persons in the
vicinity. Make sure that the
workplace is well ventilated.
Always wear safety goggles,
safety gloves and respiratory
protection. Attach a dust ex-
traction system.
1) SPECIAL SAFETY INFORMATION
FOR THE CORDLESS COMBINA-
TION TOOL
Hold the electric tool by the in-
•
sulated gripping surfaces when
performing work in which the
cutting tool may come into con-
tact with hidden wiring. Contact
with a live wire can also cause a
GB
11