Herunterladen Inhalt Inhalt Diese Seite drucken

Using / Changing The Batteries; Operation; Switching On And Off; Releasing The Plunge Lock - Parkside PTS 500 A1 Originalbetriebsanleitung

Vorschau ausblenden Andere Handbücher für PTS 500 A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

DANGER
Do not attempt to recharge batteries. Do not
charge batteries unless they are explicitly
labelled as "rechargeable". There is a risk of
explosion!
Check the condition of the batteries at
regular intervals. Leaking chemicals can
cause permanent damage to the device. Take
particular care when handling damaged or
leaking batteries. Risk of chemical burns!
Wear protective gloves.
Chemicals which leak from a battery can
cause skin irritation. In the event of contact
with the skin, rinse with copious amounts of
water. If the chemicals come into contact with
your eyes, rinse thoroughly with water, do not
rub and consult a doctor immediately.
Keep batteries out of the reach of children.
Children might put batteries into their mouth
and swallow them. If a battery has been
swallowed, seek medical assistance IMME-
DIATELY.
Do not mix different types of batteries.
Always insert the batteries the right way
round (observe correct polarity) otherwise
there is a danger that they could explode.
If you do not intend to use the device for a
long time, remove the batteries.

Using / Changing the batteries

Open the cover of the battery compartment
with a suitable Philips screwdriver.
If necessary remove the spent batteries.
Insert two new 1.5 V alkaline button cells (type
AG 13/LR 44, e.g. GPA 76) observing the
correct polarity and screw the battery compart-
ment cover
firmly closed.
CAUTION!
If operating and adjustment equipment is used or
procedures other than those specified here are
carried out, this may result in hazardous radiation
exposure.
PTS 500 B2

Operation

Switching on and off
Switching on:
Pull the ON / OFF switch
Switching off:
Release the ON/OFF switch

Releasing the plunge lock

Push the plunge lock
pressed.

Selecting the cutting depth

NOTE
We generally recommend setting the cutting
depth to approx. 2 mm more than the
thickness of the material. This ensures that you
achieve a clean cut.
Release the quick-release lever for setting the
cutting depth
, and set the desired cutting
depth on the dial
lease lever again.

Fitting the rip fence

Loosen the rip fence screw
plate
and insert the rip fence
rip fence slot
. Tighten the screw

Handling the plunge saw

1. Place the machine on the material and switch
on, as described in the chapter "Switching on
and off".
2. If necessary, align the machine using the rip
fence
or by using a marked line.
3. Push the plunge lock
pressed.
4. Saw by applying moderate pressure.
Types of saw blades:
The types of saw blades supplied cover the most
common fields of application.
back.
.
forward and keep it
and clamp the quick-re-
on the base
11a
into the
again.
11a
forward and keep it
GB
 11

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis