Speaker Settings - Yamaha DVX-S100 Bedienungsanleitung

SETUP MENU

Speaker settings

When you adjust speakers while DISC DIRECT is
functioning, follow the procedures described below.
CODE SET
SHIFT
HALL
1
SPORTS MONO MOVIE
5
PLAY MODE
/DTS SELECT
9
TOP MENU
LEVEL
u, d, j, i
CH
/ ENTER
TEST
ON SCREEN
(U.S.A. model)
If you wish to enjoy multi-channel sound reproduction,
you need to select "Multi-channel" on the setup menu and
make following adjustments.
When you select "2-channel", that is, when connecting to
only 2 speakers or a Dolby Pro Logic decoder, the
following adjustments are not necessary.
Front (L)
a
Exit
SETUP
L
Exit
Test
SELECT
LS
ENTER RETURN
Test signal
(L) a (L) c b (R) c (R) a
52
DVD-A DVD-V
VIDEO 1
CD
DVD AMP
JAZZ ROCK ENTERTAINMENT
2 3 4
SETUP ANGLE MARKER
MOVIE 1 MOVIE 2
6 7 8
REPEAT A–B
MATRIX 6.1 STEREO
> – 10
0 CANCEL
GROUP PAGE
MENU
SET MENU
MUTE
PRESET
ABCDE
CH
ENTER
PRESET
B. BOOST
VOL
RETURN
Center Front (R)
b a c a
R
ms C dB
0
0
dB
SW
0
dB ms dB
RS
0 0 0
Rear
Subwoofer
b a
a Output mode
Change the settings of each speaker in accordance with
your speaker system.
1
Press the cursor buttons (u, d, j, i) to
select a speaker and press ENTER.
2
Press the cursor buttons (u, d) to select the
setting and press ENTER.
• Choices of the speaker size
L: Large, Small
R: Large, Small
C: Large, Small, None
SW: Used, Not used
LS: Large, Small, None
RS: Large, Small, None
The size of L is set to be the same as that of R.
Therefore, if you select Large for L, the size of R is
automatically set to Large. This also applies to the
sizes of LS and RS.
• Example: Rear left speaker
1 2
LS
1 when the speaker is not used.
2 when using a large speaker capable of low-
frequency (under 100 Hz) output.
3 when using a small speaker that is not capable of
low-frequency output. (the included speakers,
NX-S100S etc.)
• Factory settings of the speaker sizes
L/R: Large
C/LS/RS: Large
SW: Used
3
LS