Checking The Accessories; Installing Batteries In The Remote Control - Yamaha DVX-S100 Bedienungsanleitung

Check your package to make sure it contains the following items.
DVR-S100
Remote control Batteries (x2)
(AA, R06, UM-3)
POWER POWER
TV AV SLEEP
TV MODE
INPUT TUNER
CH VOL
MD
MUTE CD–R
SUBTITLE AUDIO
REC VCR
VIDEO 2
VIDEO 1
CODE SET CD
SHIFT DVD AMP
HALL JAZZ ROCK ENTERTAINMENT
1 2 3 4
SETUP ANGLE MARKER
SPORTS MONO MOVIE MOVIE 1 MOVIE 2
5 6 7 8
PLAY MODE REPEAT A–B
/DTS SELECT MATRIX 6.1 STEREO
> – 10
9 0 CANCEL
Indoor FM antenna
GROUP PAGE
TOP MENU MENU
LEVEL SET MENU
MUTE
PRESET (U.S.A., Canada and
FREQ/ ABCDE
RDS
CH CH
ENTER General models)
PRESET
TEST B. BOOST
VOL
ON SCREEN RETURN
MODE PTY SEEK START

INSTALLING BATTERIES IN THE REMOTE CONTROL

Insert the batteries in the correct direction by aligning the
+ and – marks on the batteries with the polarity markings
(+ and –) inside the battery compartment.
1
1
Press the part and slide off the battery
compartment cover.
2
Insert the two batteries (AA, R06, UM-3 type)
with + and – oriented properly.
3
Slide the cover back on so that it snaps into
place.

CHECKING THE ACCESSORIES

AM loop antenna
(Europe, U.K. and
Australia models)
2
3
NX-SW100 (NX-S100S x4, NX-S100C, SW-S100)
Fasteners (4 sets) Pads
for the center (2 sets: 16 pieces)
speaker
Speaker cables
(for the rear speakers: 15m (x2),
for the front/center speaker:
5m (x3))
I Notes on batteries
• Change all of the batteries if you notice a decrease in
the operating range of the remote control.
• Do not use old batteries together with new ones.
• Do not use different types of batteries (such as alkaline
and manganese batteries) together. Read the packaging
carefully as these different types of batteries may have
the same shape and color.
• If the batteries have leaked, dispose of them
immediately. Avoid touching the leaked material or
letting it come into contact with clothing, etc. Clean the
battery compartment thoroughly before installing new
batteries.
Preserving the manufacturer code
Replace batteries early before they become unusable.
The manufacturer code set by the user will be
preserved for about two minutes when batteries run
out or when they are removed. Note that the
manufacturer code setting may be lost if more than
two minutes elapses. Also, if you press any button on
the remote control accidentally while replacing
batteries, the manufacturer code will be lost.
Non-skid pads
(2 sets: 16 pieces)
System connector
cable (5m x 1)
3