Operation; Switching On And Off; Infl Ation - Parkside PKZ 180 B2 Originalbetriebsanleitung

Operation

GB
NOTE
IE
► The appliance vibrates during operation.
Therefore, always put it down during opera-
tion. There are four feet
the appliance for this purpose.
♦ Remove the required accessories from the ac-
cessory compartment
Switching on and off
Switching the appliance on:
♦ Move the ON/OFF switch
"I" to switch the appliance on. The integrated
control lamp lights up.
Switching the appliance off :
♦ Move the ON/OFF switch
"O" to switch the appliance off . The integrated
control lamp goes out.
CAUTION!
►
Caution! This appliance is not designed for
continuous operation. To prevent the motor
from overheating, the appliance may only be
used as follows: within a period of 10 min-
utes the appliance may only be operated at
the rated power input for 15% of the period,
in other words, 1.5 minutes. During the rest of
the time period (cooling phase 8.5 minutes),
the appliance cools down again.
Compressed air hose with quick coupler
Connecting:
♦ Push the compressed air connector
quick coupler of the compressed air hose
the sleeve automatically springs forwards.
Cutting:
♦ Pull back the sleeve on the quick coupler of
the compressed air hose
compressed air connector
CAUTION!
► Caution! When disconnecting the quick
coupler of the compressed air hose
the coupler fi rmly to prevent injuries caused
by the hose fl ying off .
6
on the bottom of
.
into the position
into the position
into the
,
and remove the
.
, hold
Infl ation
with adapter
Schrader valve, car tire valve
Area of use:
This application allows for a simple and accurate
infl ation of car tires. The manometer
check the tire pressure. Thanks to the integrated
release valve it is possible to reduce the tire
pressure if it is too high.
ATTENTION!
► Please note, the manometer
brated! After infl ation, always check the tire
pressure immediately, for example, at a petrol
station.
♦ Ensure that the ON/OFF switch
♦ Press the lever quick coupler
attach it.
♦ Place the lever quick coupler
and then release the lever.
♦ Insert the mains plug
a mains power socket.
♦ Switch the ON/OFF switch
grated control lamp lights up.
♦ Read the air pressure from the manometer
♦ Switch the ON/OFF switch
as the correct or permissible air pressure has
been reached. The integrated control lamp
goes out.
♦ Press down the lever quick coupler
it off the valve.
♦ Remove the mains plug
power socket.
is used to
is not cali-
is set to "O".
downwards to
onto the valve
of the compressor into
to "I". The inte-
.
to "O" as soon
and pull
from the mains
PKZ 180 B2