Operation; Connecting The Compressed Air Supply - Parkside PDSP 1000 B2 Originalbetriebsanleitung

■
RISK OF EXPLOSION! The compressed air
sandblaster gun should not be used in areas
with gas/open flames/fire/gas-operated
water heaters.
■ SMOKING PROHIBITED!
■ Work only in sufficiently ventilated rooms.
■ Do not use oxygen or any combustible gas as
an energy source.
■ Never exceed the maximum operating pressure
of 6.3 bar.
WARNING!
► KICKBACK FORCES! At high working pres-
sures, kickback can occur which can, under
certain circumstances, lead to danger due to
continuous loads.
■ RISK OF INJURY! Disconnect the appliance
from the compressed air source before starting
any repairs or maintenance work and before
transportation.
■ RISK OF INJURY! Disconnect the appliance
from the compressed air source before refilling
the blasting medium.
NOTE
► Please heed the safety instructions provided
by the manufacturer of the blasting medium.
■ Use only materials that are suited for use in the
compressed air sandblaster gun
use quartz sand. This can lead to a dangerous
build-up of silicosis-inducing dust.
■ Take steps to ensure that others are not incon-
venienced (dust formation).
■ Ensure that the blasting medium is collected so
that it can be disposed of in an environmentally
friendly manner.
■ Do not remove any type plates. These contain
important information for the safe operation of
the appliance.
■ If you are inexperienced with the appliance,
seek training in how to use it safely.
│ GB │ IE
■ 4
WARNING! TOXIC DUST!
► Working with the tool can produce harmful/
toxic dusts which represent a health hazard
for the person operating the appliance and
for anyone else in the vicinity.
CAUTION!
► Ensure that the appliance is disconnected
from the air supply when not in use, when ex-
changing accessories or during repair work.
The air hose should not be under pressure.

Operation

Connecting the compressed air supply

NOTE
► The compressed air sandblaster gun
only be operated on cleaned, condensate-
and oil-free compressed air and may not
exceed the maximum operating pressure of
6.3 bar at the appliance.
To ensure that you can regulate the air pres-
sure, the compressed air source should be
equipped with a (filter) pressure reducer.
♦ Connect the compressed air sandblaster gun
to a suitable compressed air source by attaching
the quick-connect coupling on the supply hose
. Do not to the nipple
The connection locks automatically.
NOTE
► Ensure that the control dial
before connecting the appliance to the com-
pressed air source.
on the sandblaster gun
is set to "0"
PDSP 1000 B2
may
.