Herunterladen Inhalt Inhalt Diese Seite drucken

Exiting The Program - Monacor WALL-05DT Bedienungsanleitung

Aktiver lautsprecher für dante-netzwerke
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

At the administrator level, manual selection of the firmware is also
possible . To open the File Explorer, go to "File Load Factory Settings"
in the menu of the configuration window . A flash image file (exten-
sion " .ffi") does not only contain the presets and the corresponding
settings and access options; it also contains the complete firmware .
Note for loading a flash image file (*.ffi): When a flash image is loaded, a
firmware update will be made and then a factory file will be loaded .
A firmware update will reset the unit to automatic IP address assignment
("Network Settings"
 chapter 7 .11) . Therefore, the computer may no longer
be able to access a unit that was previously set to a fixed IP address . As a result
of this disconnection, the flash image file may not be loaded completely .
Important: Before loading a flash image file, make sure that an IP address has
automatically been assigned both to the PC network interface and to the unit .

7.2.6 Exiting the program

To exit the program, call up the menu item "File Quit" or close the
program window .
45

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis