The Dsp Control Program; Installing The Pc Software; Calling Up The Control Program - Monacor WALL-05DT Bedienungsanleitung

7 The DSP Control Program

7.1 Installing the PC software

The required software is available for download on our website under
"Service / Downloads" .
https://www .monacor .com/en-gb/monacorinternational/service/
These instructions refer to the version 3 .8 .22 of the PC software . To
install the DSP control program, a computer with the operating system
Windows XP with Service Pack 2 or later or Mac OS X, version 10 .5 .8
or later and an Ethernet interface is required . The screen resolution
should be at least 1024 × 768 pixels .
– To install the PC software on a Windows system, start the suitable
installation program "MONACOR_DSP_Controller [...] .msi" and
follow the instructions of the installation program .
– On a computer with Mac OS X system, start the program "MONA-
COR DSP Controller .app" .

7.2 Calling up the control program

1) Call up the control program "DSP Controller" on the computer .
2) If a password has been assigned to the program (
a window will appear requesting to enter the password . Enter the
password .
If the password is not correct, the message "Invalid password"
will appear . In this case, confirm the message and enter the correct
password .
The overview window (fig . 10) will appear, listing all units connected .
The line "All units" at the top will indicate the number of units which
are currently "on line" in brackets, i . e . units which are actively con-
nected to the computer . Beneath this line, there are lines with infor-
mation and functions for each unit .
Fig. 10 Overview window
Note: The program "DSP Controller" is not only used to control speakers of the
type WALL-05DT but also other units from MONACOR with integrated signal
processor . Therefore, the list also contains DSM-48LAN .
☞
chapter 7 .2 .2),
41