Routing With The Dante Controller - Monacor WALL-05DT Bedienungsanleitung

5.3 Routing with the Dante Controller

To assign the input signals and output signals of the corresponding
units:
1) Under "Routing" in the window "Network View", click
the channels of the desired Dante transmitter under "Dante Trans-
mitters" and the channels of WALL-05DT under "Receivers" .
2) Navigate from the Dante transmit channel to the line of the desired
Dante receive channel of WALL-05DT and click the field .
3) Wait for the field to show a green circle with a white check mark
(refer to fig . 8) .
4) Repeat the last two steps for the second Dante receive channel of
WALL-05DT, if required .
⊞
to open
Fig. 8 Audio routing from the audio source "VirtualSoundcard"
to the receiver "WALL-05DT"
An English user guide for the Dante Controller is available for down-
load on the Audinate website:
https://www .audinate .com/resources/technical-documentation
39