Configuration Of The Unit With The Dante Controller - Monacor WALL-05DT Bedienungsanleitung

5.2 Configuration of the unit with the Dante Controller

1) Start the Dante Controller .
2) Wait for the desired Dante transmitter and WALL-05DT to appear
in the matrix (under "Dante Receivers") .
Note: If WALL-05DT or the Dante transmitter fails to appear, the reason may
be that the corresponding unit has not been switched on, that the unit is in a
different subnet or that the unit is not able to synchronize with the other Dante
units . However, if one of the two last-mentioned reasons applies, the Dante
unit should at least appear under the tab "Device Info" or "Clock Status" in
the network view . A fast solution of the problem may be to switch off the unit
or to disconnect the connection to the switch . For further information please
refer to the user manual of the Dante Controller from Audinate .
3) In the menu bar of the Dante Controller, select "Device/Device
View" or use the shortcut Ctrl+D . The Device View window will
open .
4) Select "WALL-05DT" in the bar of the drop-down menu appearing
beneath the menu bar .
5) The third bar can be used to indicate information on the unit and
to make settings . Select the tab "Device Config" (refer to fig . 7) .
6) Adjust the "Sample Rate" to the desired Dante transmitter or set
a different common sample rate for both units, if required .
7) In the field "Rename Device", the name used for the unit in the
Dante network can be changed (e . g . to a specific name referring
to the place of installation) . Click "Apply" to confirm the change .
38
Fig. 7 Device View of WALL-05DT
8) Use the tab "Network Config" to change the network settings for
the Dante interface of WALL-05DT, if required .