Other Accessories; Adjusting The Disc Guard Cover - Parkside PWS 125 A1 Betriebsanleitung

Use of accessories
©

Other accessories

You can also use abrasive consumables and tools
complying with the following technical specification:
Spindle thread:
Speed:
Backing plate for grinding discs
Dimensions:
Grinding discs for wood / masonry attached
with hook and eye fixings
Dimensions:
Note! These may only be used in combination
with a backing plate!
Cup brush, crimped wire
Dimensions:
Speed:
16 GB/IE
M14
min. 12000 rpm
ø 115 mm / 125 mm
ø 115 mm / 125 mm
ø 75 - 100 mm
min. 12000 rpm
Cup brush, twisted wire
Dimensions:
Speed:
Cup brush, knotted wire
Dimensions:
Speed:
©

Adjusting the disc guard cover

½
WARNING!
Pull the mains plug out of the mains socket
before you carry out any task on the device.
DANGER OF INJURY! Always use the an-
gle grinder with the disc guard cover
place. The disc guard cover must be securely
attached to the angle grinder. To ensure the
highest level of safety while using the device,
ensure that the smallest possible area of the
grinding or cutting tool is exposed to the oper-
ator at all times (see Fig. B, C). The disc guard
cover is there to protect the operator from
5
pieces breaking off and accidental contact
with the grinding or cutting tool. The disc guard
cover has 5 set positions.
Turn the disc guard cover
position (working position). The closed side of
the disc guard cover
the operator.
ø 75 mm
min. 12000 rpm
ø 115 mm
min. 12000 rpm
DANGER OF INJURY!
in
5
into the desired
5
must always be facing
5