Herunterladen Inhalt Inhalt Diese Seite drucken

Safety Instructions For Motor Carving Devices; Original Accessories / Additional Equipment; Operation; Turning The Device On / Off - Parkside PSG 50 A1 Betriebsanleitung

Motorschnitzgerät
Vorschau ausblenden Andere Handbücher für PSG 50 A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

cutting edges are less likely to jam and are
easier to control.
g) Use the electrical power tool, accesso-
ries, inserted tools etc. in accordance
with these instructions and advice, and
the stipulations drawn up for this par-
ticular type of device. In doing this, take
into account the working conditions
and the task in hand. The use of electrical
power tools for purposes other than those in-
tended can lead to dangerous situations.
Safety instructions for
motor carving devices
In order to avoid injury, fire and health
hazards:
½
Secure the work piece. Use clamping
devices / a vice to hold the work piece.
It is then held more securely than with your hand.
½
Wear protective goggles!
There is a danger of injury from
splintering materials flying into your
eyes etc.
½
Wear a dust mask! During pro-
longed working with wood and par-
ticularly if materials are processed
which produce dusts that are hazardous to the
health.
½
Do not soak materials or areas which
are to be worked on with solvent-con-
taining liquids. Shaving of the materials may
produce harmful / toxic vapours.
½
Material containing asbestos must not
be processed with this device. Asbestos
is a known carcinogen.
½
Under no circumstances should you
prop up your hands next to or in front
of the device or the area to be worked
on. There is a danger of injury from the very
sharp attachment tools.
½
Always route the cable towards the back away
from the device.
½
In cases of danger remove the plug from the
socket immediately.
General safety advice for electrical power tools / Operation
©
Original Accessories /
Additional Equipment
½
Use only the accessories and additional
equipment referred to in the instruc-
tions. The use of tools or other accessories
which are not recommended in the instructions
may represent a risk of injury.
©

Operation

©
Turning the Device On / Off
Insert the mains plug into a socket.
Switching on:
Press the ON / OFF switch
position.
Switching off:
Press the ON / OFF switch
position.
©

Inserting / Replacing Blades

WARNING!
DANGER OF INJURY!
Before performing any work on the device, turn the
device off and remove the mains plug.
DANGER OF INJURY! The
WARNING!
carving blades have a very sharp edge.
½
During assembly and the final check
of the blade you should wear ap-
propriate protective gloves.
The selection of the correct carving blade depends
on the specific application. The carving blades sup-
plied are suitable for the most common applications
(see Figures B - D).
Release the cap nut
anticlockwise direction.
Remove the blade if necessary. Insert another
blade into the tool holder
Re-tighten the cap nut
clockwise direction.
to the "I"
1
to the "0"
1
with the key
in an
6
8
as far as it will go.
5
with the key
in a
6
8
GB/IE
9

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis