Changing Between Clockwise And Counter Clockwise Direction; Drilling/Hammering; Maintenance And Cleaning - Westfalia SBMB 600 Original Bedienungsanleitung

The required rotation speed for drilling depends on the material being
drilled. It is best selected by a practical test.
2. The ON/OFF trigger can be locked in the pushed (ON) position by
pressing the locking pin (6). The locking pin releases automatically when
the ON/OFF trigger is pressed again.

Changing between clockwise and counter clockwise direction

The switch for clockwise/counter clockwise operation (5) should only be
operated when the motor is at a complete standstill. When the ON/OFF trigger
(4) is depressed, the switch for clockwise/counter clockwise operation (5) is
disengaged.
Clockwise Rotation:
Counter Clockwise Rotation:
Drilling/Hammer-Drilling
The drilling/hammer-drilling selector (7) is located on the top of the machine.
Hammer-Drilling
Push the switch towards the hammer
Drilling
Push the switch towards the drill

Maintenance and Cleaning


Always disconnect the machine from the power supply before maintaining
or cleaning it.

Ensure that the ventilation slots are open and clean before each use.

Never clean the machine with water. Use a soft cloth to clean the housing.
Do not use aggressive chemicals or solvents to clean the machine as
these may damage the plastic case.

The mechanical parts of the machine are maintenance free.
Operation
For clockwise operation, push the clock-
wise/counter clockwise switch all the way to
the right (for drilling, fastening of screws).
Push the clockwise/counter clockwise switch
all the way to the left (for e.g. for screw re-
moval).
symbol.
10
symbol.