Safety Instructions For All Applications - Parkside 275389 Originalbetriebsanleitung

• Disconnect the plug from the po-
wer source and/or the battery
pack from the power tool before
making any adjust -ments, chan-
ging accessories, or storing power
tools. Such preventive safety measures
reduce the risk of starting the power tool
accidentaIly.
• Store idle power tools out of the
reach of children and do not al-
low persons unfamiliar with the
power tool or these instructions to
operate the power tool. Power tools
are dangerous in the hands of untrained
users.
• Maintain power tools. Check for
misalignment or binding of mo-
ving parts, breakage of parts
and any other condition that may
affect the power tool's operation.
If damaged, have the power tool
repaired before use. Many accidents
are caused by poorly maintained power
tools.
• Keep cutting tools sharp and
clean. Properly maintained cutting tools
with sharp cutting edges are less Iikely to
bind and are easier to control.
• Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions
and the work to be performed.
Use of the power tool for operations diffe-
rent from those intended could result in a
hazardous situation.
Service:
• Have your power tool serviced by
a qualified repair person using
only identical replacement parts.
This will ensure that the safety of the pow-
er tool is maintained.
Safety instructions for all
applications
Common safety instructions for
grinding, sanding, working with
wire brushes polishing and cutting
grinders:
• This electric tool is to be used as
a grinder, sander, wire brush,
polisher and cutting grinder.
Follow all safety instructions,
directives, illustrations and facts
which you receive with the de-
vice. If you do not follow these instruc-
tions, an electrical shock, fire and/or
serious injury may occur.
• Do not use any accessories that
are not specifically intended and
recommended for this electric
tool by the manufacturer. Simply
because an accessory can be attached
to your electric tool does not guarantee
safe operation.
• The allowable rotation speed
of the attachment tools must be
at least as high as the highest
rotation speed indicated on the
electric tool. Accessories that run fas-
ter than the allowable speed can break
and fly apart.
• The outside diameter and thick-
ness of the attachment tool must
correspond to the dimensions
indicated for your electric tool.
Attachment tools which are wrongly
dimensioned cannot be sufficiently shiel-
ded or controlled.
• Attachment tools with threaded
attachment must fit the threa-
ding of the grinding spindle ex-
actly. For attachment tools which
are mounted through a flange,
GB
31