Supplement to the Instructions for the
55001 Live Steam Locomotive
1 Installating the Receiver
The receiver is not delivered installed in the tender in order to prevent damage
to the receiver. You must therefore mount the receiver in the tender and con-
nect it to the rest of the locomotive's circuit before operating the locomotive
for the first time.
Connecting the receiver to the rest of the locomotive's
circuit
Fig. 1: Loosen the tender from its display board
Supplement to the Instructions for the 55001 Live Steam Locomotive
The following connectors and sockets are located in the tender:
• Three-conductor connection (1) from the electronic control circuit
• Two-conductor connection (socket 2) from the on/off switch for the
receiver
• Two-conductor connection (plug 3) from the on/off switch to the battery
holder
• In addition, there is also the three-conductor connection (4) from the servo
in the locomotive, when the tender is coupled to the latter.
3
1
Fig. 2: Connections
2
4
13