Wall Mounting; Charging The Battery - Ideen Welt HS-W60-04 Bedienungsanleitung

WALL MOUNTINg

1. For the wall bracket (12), choose a dry area near an appropriate socket.
2. Before drilling, mark the two holes.
Danger of Death! When drilling, beware of electrical wiring or other conduits and
pipes that are located in the wall.
3. Stick the wall plug (10) into the boreholes and screw the wall bracket securely onto the wall
using the screws (9).
4. Stick the jack plug (13) into the wall bracket (12) and lay the cable of the mains adaptor (11)
into the guideway (see components 11, 12,13).

ChARgINg ThE BATTERY

Important! Completely charge the battery before using the device for the first time, in order to
attain the maximum charge capacity. Initial charging lasts approx. 24 hours, subsequent charging
time is approx. 5 hours.
1. Slide the vacuum cleaner from above onto the wall bracket (12). The dust collector (1) points
upwards.
2. If you prefer not to use the wall bracket, stick the jack plug (13) of the mains adaptor (11) into
the jack (7).
3. Connect the mains adaptor to an appropriate power outlet. The vacuum cleaner must be
switched off for charging.
4. The charge indicator light (5) flashes red.
5. When the battery is charged, the charge indicator light (5) flashes green.
6. The vacuum cleaner is completely charged after approx. 5 hours.
The vacuuming time is 10 to 15 minutes.
7. After the charging process has ended, lift the vacuum cleaner off the wall bracket or remove
the jack plug (13) from the device.
8. Pull the mains adaptor (11) out of the power outlet.
Please note: If you are not going to use the vacuum cleaner for a long period of time, take it out of
the charging station and pull the mains adaptor out of the socket.
USE
1. The vacuum cleaner can be operated with or without attachments.
Choose the appropriate attachment, as needed:
Brush attachment (14), for dusting delicate objects
Nozzle attachment (15), for vacuuming difficult-to-reach places
Wet attachment (16), for vacuuming up small quantities of fluid (capacity approx. 150ml).
2. Stick the chosen attachment on the front of the collecting chamber (1).
3. Push the on/off switch (6) forwards, in order to turn the device on. The charge indicator light
(5) glows green.
4. Move the device steadily over the area to be cleaned.
5. Push the on/off switch back, in order to turn the device off. The charge indicator light (5)
goes out.
6. Empty and clean the collecting chamber (1) after every use (see Cleaning and Maintenance).
P140316-R4G-HS-W60-04-WetDryVacuumCleaner_20141117_V2.indb 11
11
t
28/11/14 10:21 AM