Correctly Holding The Equipment; After Initial Use; Maintenance; Cleaning And Care - Parkside PDSS 310 A3 Bedienungs- Und Sicherheitshinweise

Commissioning / After initial use / Maintenance / Cleaning and Care
Correctly holding the
equipment
This equipment weighs 2.1 kg.
Hold the equipment with both hands to ensure
safe operation (see Fig. D).

After initial use

Once the task has been finished the device must be
disconnect from the compressed air supply
Switch off the compressor.
Briefly activate the trigger
to release any residual compressed air.
Now pull back the safety on the connection
coupling of your compressed air hose.
Now remove the hose from the plug nipple
Careful when putting the
device down. Always put down the device so it
does not rest on the trigger. This could potenti-
ally result in inadvertent activation of the tool,
which in turn could result in hazards.

Maintenance

ATTENTION! All maintenance must be per-
formed by trained individuals. Follow the specified
maintenance instructions to ensure a long life and
proper operation of this quality product.
Disconnect equipment from the compressed air
source when performing maintenance and care.
Check the condition of wear and tear items
and accessories with each maintenance.
Note: Daily cleaning and regular lubrication
are an absolute necessity for smooth operation.
Only use special tool oil with a high viscosity
(thin fluid). Oil for compressed air tools or
SAE10-20 motor oil are suitable.
ATTENTION! Do not use other (especially
high viscosity) lubricants. Malfunctions or per-
manent damage may otherwise occur.
The following lubricating options are
available:
a) via the lubricator
b) via oil-mist generator
.
2
of the equipment
4
. c) by hand
9
Note: Regular lubrication is imperative to ensure
the longest possible life for your compressed air de-
vice. We recommend continuous lubrication via the
included lubricator
11
Fill the lubricator included
by first unscrewing the inlet screw from the lu-
bricator.
Now install the lubricator
11
air supply as described in chapter „Establishing
connections".
If a complete maintenance unit with oil-mist
generator is installed on your compressor the
lubricator does not necessarily need to be
11
mounted.
To use the oil-mist generator plug the plug
nipple directly into the equipment and con-
9
nect with your air hose.
Alternatively you can also manually lubricate
your equipment (not recommended).
To do so, remove the screw plug on the oil filler
port .
5
Apply 3–5 drops of oil to the compressed air
connection and the oil filling port
using the compressed air tool.
If the air tool has not been used for several
days 5–10 drops of oil must be added to the
air connection and the oil filler port
2
.
11
Always store your air tools / equipment in dry
locations.
No maintenance is required beyond the above
lubrication and cleaning.

Cleaning and Care

Only clean the tool with a dry cloth.
Never clean with fluids such as petrol, solvents
or water.
Do not allow liquids to enter the equipment.
with a bit of oil
11
in the compressed
before
5
.
5
GB 13