Yamaha HAIBIKE SDURO HardSeven RC 2016 Originalbetriebsanleitung Seite 69

Display angle
adjust bolt
Power switch
Mounting and removing the display
To mount the display, press the lever on the holder while sliding the display towards
the rear of the bicycle into the holder. To remove the display, press the lever while
sliding the display towards the front of the bicycle out of the holder.
TIP
Adjust the display angle by loosening the display angle adjust bolt. The angle depends
on each rider.
Do not remove it while riding.
Make sure the display is turned off before mounting or removing it.
Power "On/Off"
Each time you press the power switch, the power switches between "On" and "Off".
When you turn on the power, all of the displays light up.
After that, the battery capacity indicator, speedometer, assist power meter, the func-
tion display such as average bicycle speed, and "STD" of assist mode indicator, and
clock and thermometer are displayed.
TIP
• When you turn on the power, the assist mode is automatically set to Standard
mode.
• Keep your feet off the pedals when turning on the display unit. Also, do not start
riding immediately after turning on the display unit. Doing so could weaken the assist
power. (Weak assist power in either of these cases is not a malfunction.) If you did
either of the above by accident, remove your feet from the pedals, turn on the power
again, and wait a moment (approximately
two seconds) before starting to ride.
English
69