Display; Install - Pioneer N-50AE Bedienungsanleitung

> Before Start > Part Names

Display

1. The source is displayed.
(USB Front / USB Rear / USB DAC In / Music Server / Network / Digital In 1 / Digital In 2)
2. The name of the file, artist, album, etc., is displayed.
3. Displays the play status.
4. Displays file format, sampling frequency, and quantization bit information.
5. The file play status is displayed. This may not be displayed depending on the input or file.
6. This is displayed when the Lock Range Adjust setting is set to other than "Range 7".
( P24)
7. Lights in the following conditions.
: When the connection setting on the unit is "Wired" and the unit is connected to the network.
: When the connection setting on the unit is "Wired" and the unit is not connected to the network.
: When the connection setting on the unit is "Wi-Fi" and the unit is connected to the network.
: When the connection setting on the unit is "Wi-Fi" and the unit is not connected to the network.
8. If an album jacket is recorded for the file being played, it is displayed here.
9. This is displayed when the digital audio output setting is on. (
8
> Install > Initial Setup

USB Front
Song

Artist
Album

FLAC

44.1 /24
kHz bit

00:01:45 / 00:03:23
L.R.A ASR

P29)
> Playback
Supplementary information | Advanced Setup | Others



D.OUT


10.Lights in the following conditions.
: When all track repeat play is on
: When one track repeat play is on
1
: When shuffle play is on
11. This is displayed when the Auto Sound Retriever feature is on. (
0 When DISPLAY on the remote controller is pressed to turn off the display, the unit may
appear the same as if you had unplugged the unit from the power outlet, but electricity is
still being supplied to the unit. To completely cut the unit off from the power supply, you
need to unplug the power plug (shutoff device) unit from the power outlet.
E
N
P24)