System Info; Factory Reset - Pioneer N-50AE Bedienungsanleitung

> Before Start > Part Names
Format Format the HDD connected to the USB port on the rear of the main
unit. In order to use a computer connected to the same network as
this unit to access an HDD connected to this unit, the HDD needs
to be formatted by this unit. When you format the HDD, all data on
the HDD will be deleted, so you should backup data before
formatting. To format, select "Start", and then press ENTER.
0 The tracks, files, etc., on an HDD formatted on this unit cannot
be viewed even when directly connected to a computer.
∫ Language
Select the language displayed on the display.
English (Default Value), German, French, Spanish, Italian, Dutch, Swedish, Russian,
Chinese
∫ Digital Out
Make settings for digital audio output.
"On" (Default Value), "Off"
∫ Balance Out (N-70AE only)
You can switch the phase of the XLR ANALOG OUT jack of this unit to match the phase of
the XLR jack on the connected device.
"2-HOT/3-COLD" (default value), "2-COLD/3-HOT"
0 When connecting an integrated amplifier or other device with an analog audio cable,
select "2-HOT/3-COLD". The phase of the output audio is reversed when you select "2-
COLD/3-HOT".

System Info

The MAC address of this unit and the current firmware version will be displayed.
> Install > Initial Setup > Playback
Supplementary information |

Factory Reset

Reset the settings of this unit to the status at the time of shipment. We recommend that you
take a note of the settings you have changed before going ahead with a factory reset. Select
"Start" and confirm to go ahead. The unit will be placed on standby automatically when
initializing is completed.
Update
"Update" is not displayed if there are no firmware updates.
∫ via Network
Press ENTER to select when you want to update the firmware via network.
∫ via USB
Press ENTER to select when you want to update the firmware via USB.
Web Setup
You can make Wi-Fi connection settings using a web browser on a computer. Be sure your
computer is connected to the router wirelessly.
If this unit is connected to the router using ethernet cable, you can not do this setting.
1. Turn the unit on.
2. Press SETUP on the remote controller, select "Wi-Fi" in "Network Setting" - "Connection",
then select "Wi-Fi Setup".
3. Press / to select "Use iOS Device" and press ENTER.
4. In the list of wireless LAN connections on your computer, select SSID of this unit
(softap_0009B0xxxxxx).
0 "xxxxxx" in SSID is the lower three bytes of the MAC address.
5. Open the web browser on your computer and access http://192.168.200.1.
6. The "Web Setup" menu is displayed. Make network settings for this unit.
0 Depending on the equipment being used or connection environment, this function may
not work.
0 Consult the appropriate operating instructions for information regarding operation of the computer.
0 Since this kind of connection is not encoded, a minor security risk may be involved.
Advanced Setup | Others
E
N
29