Mounting The Table Width And Length Extension; Mounting The Suction Adapter; Mounting The Riving Knife - Parkside 273460 Originalbetriebsanleitung

G B I E
Caution! Both stand brackets
must be attached to the rear
of the machine at attachment
points 38!
8. Then tighten all of the bolts and nuts of
the base.
Mounting the table width
and length extension
(Figures 11-14)
1. Loosely tighten the table width extensi-
on (7) and table length extension (15)
on the saw table using the hexagon
bolts (f). (Figure 12).
2. Loosely tighten the table supports
(25, 26) on the housing of the table
circular saw using hexagon bolts (f). In
addition, the table supports (25, 26)
also have to be loosely tightened to
the table width and length extensions.
Mounting material: Hexagon bolts (e),
washer (a) and nut (c). The short sup-
ports (25) are for the table widening
extension, the long supports (26) for
the length extension, (Figures 13, 14).
3. Turn the saw over with the base and
place it on the floor.
4. Align the table width and length exten-
sion flush with the saw table.
5. Then tighten all bolts.
Mounting the Suction
Adapter
(Figure 15)
1. Insert the suction adapter (16) into
the opening provided on the rear of
the machine. The side outlet is now
pointing outwards.
2. The suction adapter has a rubber seal;
make sure that this is mounted.
1 8
3. The adapter is secured by means of
a bayonet lock. Insert the vacuum
cleaner adapter (16) as shown in
Figure 15 and lock this in place with a
quarter turn in a clockwise direction.

Mounting the Riving Knife

(Figures 16-19)
Caution! Remove the mains plug!
The setting of the saw blade (5)
must be checked whenever a blade
has been replaced.
1. Inserting the batteries (Figure 16):
- Turn the laser on/off switch (35) to the
0 position (laser off).
- Remove the battery compartment cover
(37) by loosening the screw (36).
Now remove the battery compartment
cover (37) by bending at the side.
- Insert the batteries supplied (type
AAA), ensuring the correct polarity
(see Figure 16).
- Put the battery compartment cover (37)
back in position and tighten it with
the screw (36). Notes concerning the
batteries:
- If you are not going to use the laser
for a prolonged period, please remove
the batteries from the battery com-
partment. Otherwise, the leaking of
battery fluid might damage the device.
- Do not place the batteries on radia-
tors or expose them for a prolonged
period to strong sunlight; temperatures
above 50° could damage the device.
2. Adjust the saw blade (5) to a max.
cutting depth, move to the 0° position
and lock in place.
3. Release the screws (29). Remove the
table insert (6) (Figure 17).