Maintenance And Servicing; Safe Working - Parkside 273460 Originalbetriebsanleitung

2

Maintenance and Servicing

– Always remove the mains plug
when carrying out any adjustments
or maintenance work.
– The cause of the noise is influenced
by various factors, including the
properties of the blades, the con-
dition of the saw blade and power
tool. If possible, use saw blades
that are designed to reduce the
noise level, service the power tool
and tool attachments regularly and
repair them if necessary to reduce
noise.
- Report any faults to the power tool,
safety devices or the tool attach-
ment as soon as they are disco-
vered to the person responsible for
safety.
3

Safe Working

– Use the push stick or the handle
with push block to pass the workpi-
ece safely past the saw blade.
– Make sure that the riving knife
is always used and that this is
correctly adjusted.
– Use the upper blade guard and
adjust it correctly.
– Use only saw blades whose maxi-
mum speed is not lower than the
maximum spindle speed of the tool
being used and which are suitable
for the material to be cut.
– Do not create any rebates or
grooves unless a suitable protective
device, such as a tunnel guard, is
attached above the saw table.
– Circular saws must not be used for
slotting (cutting grooves which end
in the workpiece).
– When transporting the power
tool, use only the transport devices
supplied. Never use the guards for
handling or transporting the tool.
- During transport, make sure that
the top part of the saw blade is co-
vered, for example with the guard.
– Ensure that the only spacer
washers and spindle rings which
are used are suitable for the purpo-
se stated by the manufacturer.
– The floor around the machine must
be flat, clean and free of loose
particles such as chips and cutting
residues.
– Working position always to the
side of the saw blade.
– Do not remove any cutting residues
or other parts of the workpiece
from the cutting area for as long
as the machine is running and the
sawing unit is not yet in the rest
position.
– Secure long workpieces against
tilting at the end of the cutting
operation (e.g. unwinding stand or
roller stand).
Caution! long workpieces against
–
tilting at the end of the cutting
operation (e.g. unwinding stand or
roller stand).
– Caution! Never remove any loose
splinters, chips or jammed pieces
of wood when the saw blade is
still running.
• Always switch off the machine and
remove the plug before repairing
any faults or removing jammed
pieces of wood.
• Always switch off the motor and
remove the plug before carrying
out any conversions or adjustment,
measurement and cleaning work.
• Before switching on, check that
the spanners and adjustment tools
have been removed.
G B I E
1 3