Additional Safety Instructions; Safety Precautions - Parkside 273460 Originalbetriebsanleitung

G B I E
be carefully checked to determine
that it will operate properly and
perform its intended function.
– Check whether the moving parts
are working properly and are not
becoming jammed or whether
parts are damaged. All parts must
be correctly fitted and satisfy all
conditions to ensure the proper
operation of the power tool.
– The movable guard must not be
clamped when it is open.
– A guard or other part that is dama-
ged should be properly repaired or
replaced by an authorized service
centre unless otherwise indicated
in this instruction manual.
– Have defective switches replaced
by an authorized service centre.
– Do not use any faulty or damaged
connection cables.
– Do not use the tool if the switch
does not turn it on and off.
21 Warning!
– The use of any accessory or attach-
ment other than one recommended
in this instruction manual may
present a risk of personal injury.
22 Have your tool repaired by a
qualified person.
– This electric tool complies with
the relevant safety rules. Repairs
should only be carried out by qua-
lified persons using original spare
parts, otherwise this may result in
considerable danger to the user.
ADDITIONAL SAFETY
INSTRUCTIONS
1

Safety Precautions

– Warning! Do not use damaged,
cracked or deformed saw blades.
– Replace a worn table insert.
Regrinding is not allowed.
1 2
– Only use saw blades recommen-
ded by the manufacturer which
conform to EN 847-1. Warning!
When changing the saw blade
ensure that the cutting width is not
smaller and the main blade thick-
ness of the saw blade not greater
than the thickness of the riving
knife!
– Make sure that a saw blade is
selected which is appropriate for
the material to be cut.
- Wear appropriate personal pro-
tective equipment. This includes:
Hearing protection to reduce the
risk of becoming hard of hearing,
breathing respirator to reduce the
risk of inhaling hazardous dust.
- Wear gloves when handling saw
blades and rough materials.
- Whenever practicable, saw blades
should be carried in a container.
– Wear safety goggles. Any splin-
ters, chips and dusts which are
ejected from the device when it is
in operation may cause sight loss.
– Connect the power tool to a dust
collection device when sawing
wood. Among other things, the
emission of dust is affected by the
type of material to be machined,
the importance of local deposition
(capture or source) and the correct
setting of hoods/deflector plates/
guide mechanisms.
- Do not use any saw blades made
of high-alloy high-speed steel
(HSS).
– Always store the push stick or
push block in its holder on the
power tool when not in use.