Maintenance And Cleaning; Environmental Instructions And Disposal Information; Information About Warranty And Service Processing - Parkside PISG 80 A2 Originalbetriebsanleitung

... / Maintenance ... / Environmental instructions ... / Information about warranty ...
... / Maintenance ... / Environmental instructions ... / Information about warranty ...
Weld penetration
Weld width
Welding bead
Weld imperfections
Note: Determine which welding method is more
suitable for yourself after welding a test piece.
Note:
Once it has worn down completely, the
electrode must be replaced.

Maintenance and Cleaning

Note: The welding tool requires regular maintenance
and reconditioning to work properly and to comply
with safety requirements. Improper and incorrect
operation may result in malfunctions and damage
the tool.
Before performing maintenance work or
repairs on the welding tool, disconnect
the power cable
to ensure the tool is safely isolated from the
power supply.
Clean the exterior of the welding tool
regularly. Use compressed air, cotton
waste or a brush to remove dirt and dust.
Note:
The following kinds of maintenance work
must be performed only by suitably-qualified
personnel.
Current regulators, earthing equipment, internal
cables, the blowpipe coupler and adjusting
screw should be maintained regularly. Tighten
loose screws and replace rusty screws
(M4 × 10 replacement screws are
available from your local DIY store.)
Regularly check the leakage resistance of the
welding tool. Use suitable measuring instruments
for this purpose.
281479_Inverter Schweissgeraet PISG 80 A1_content_GB_IE_NI.indd 15
286508_Inverter Schweissgeraet_PISG 80 A2_Content_LB3.indb 45
Towards the unwelded
part:
larger
flatter
greater
from the power outlet
10
Towards the welded part:
less
In the event of a defect or if components need
to be replaced, please contact the correspond
ing professional.
Environmental instructions
and disposal information
Don't waste,
recycle!
Device, accessories and packaging
should be recycled in an environmen-
tally friendly manner.
Do not dispose of the inverter welder equipment with
your household waste, or throw into fire or water. If
possible, non-operational equipment should be re-
cycled. Contact your local retailer for information.
Information about warranty
and service processing
Creative Marketing Consulting GmbH
warranty
Dear customer, the warranty for this device is
3 years from the date of purchase. In the event of
product defects, you have legal rights against the
retailer of this product. Your statutory rights are not
limited in any way by our warranty detailed below.
greater
smaller
higher
less
GB 45
GB/IE/NI 15
28.12.16 12:22
14.02.18 08:50